相关论文: Performance Variance of Low Noise Resonant Capacit…

We describe the design principles, fabrication, and characterization of a precision AC resonant capacitance bridge (RCB) sensor, based on a resonant differential planar printed circuit board transformer with a solid (ungapped) MnZn ferrite…

The measurement of the close-to-the-carrier noise of rf and microwave devices is a relevant issue in time and frequency metrology and in some fields of electronics, physics and optics. While phase noise is the main concern, amplitude noise…

We have developed a highly-sensitive integrated capacitance bridge for quantum capacitance measurements. Our bridge, based on a GaAs HEMT amplifier, delivers attofarad (aF) resolution using a small AC excitation at or below kT over a broad…

We present a superconducting noise bolometer for terahertz radiation, which is suitable for large-format arrays. It is based on an antenna-coupled superconducting micro-bridge embedded in a high-quality factor superconducting resonator for…

We have studied low frequency resistance fluctuations (noise) in a single crystal of the rare earth perovskite manganite Pr$_{0.63}$Ca$_{0.37}$MnO$_3$ which shows a charge ordering transition at a temperature $T_{CO}$ ~ 245K. The noise…

Superconducting thin-film electronics are attractive for their low power consumption, fast operating speeds, and ease of interface with cryogenic systems such as single-photon detector arrays, and quantum computing devices. However, the…

AC loss measurements were made on a series of Rutherford cables wound from stabrite-coated NbTi/Cu multifilamentary strand, from the results of which interstrand contact resistances were calculated. The 28-strand, 15 mm wide, LHC-inner type…

We describe the design and performance of a series of fast, precise current sensing noise thermometers. The thermometers have been fabricated with a range of resistances from 1.290 $\Omega$ down to 0.2 m$\mathrm{\Omega}$. This results in…

The cryogenic performance of GaN-based HEMTs (high-electron-mobility transistors) is systematically investigated by the direct current (DC) and low-frequency noise (LFN) characteristics within the temperature (T) range from 300 K to 4.2 K.…

We present a technique to estimate the inhomogeneities of magnetic loss across the section of ferrite cores under ac excitation. The technique is based on two distinct calorimetric methods that we presented elsewhere. Both methods are based…

We developed an impedance bridge that operates at cryogenic temperatures (down to 60 mK) and in perpendicular magnetic fields up to at least 12 T. This is achieved by mounting a GaAs HEMT amplifier perpendicular to a printed circuit board…

We investigated low-frequency current fluctuations, i.e. noise, in the quasi-two-dimensional (2D) van der Waals antiferromagnetic semiconductor FePS3 with the electronic bandgap of 1.5 eV. The electrical and noise characteristics of the…

We report on the temperature dependence of the low-frequency electronic noise in NiO$_x$/Ga$_2$O$_3$ p-n heterojunction diodes. The noise spectral density is of the 1/f-type near room temperature but shows signatures of Lorentzian…

We report low-frequency noise characteristics of vertical GaN PIN diodes, focusing on the effects of the diode design, current and temperature. The as-grown and regrown diodes, with and without surface treatment have been studied. The noise…

We present measurements of 1/f frequency noise in both linear and Josephson-junction-embedded superconducting aluminum resonators in the low power, low temperature regime - typical operating conditions for superconducting qubits. The…

We have measured the low frequency (1mHz<f<10Hz) resistance fluctuations in metallic nanowires (diameter 15nm to 200nm) in the temperature range 77K to 400K. The nanowires were grown electrochemically in polycarbonate membranes and the…

To use highly resistive material for Kinetic Inductance Detectors (KID), new designs have to be done, in part due to the impedance match needed between the KID chip and the whole 50 ohms readout circuit. Chips from two new hybrid designs,…

Photonic addressing of superconducting circuits has been proposed to overcome wiring complexity and heat load challenges, but superconducting-photonic links suffer from an efficiency-noise trade-off that limits scalability. This trade-off…

Silicon spin qubits are among the most promising candidates for large scale quantum computers, due to their excellent coherence and compatibility with CMOS technology for upscaling. Advanced industrial CMOS process flows allow wafer-scale…

The electric noise can be an important limitation for applications of conducting elements of size in the nanometer range. The intrinsic electrical noise of prospective materials for opto-spintronics applications like ZnO has not been…