相关论文: Modeling and Measurement of Lead Tip Heating in Im…
Purpose: Low-field MRI has been assumed to be implant-friendly based on limited studies. However, RF-induced heating due to an implant is a complex resonance phenomenon, highly dependent on the implant's configurations and the applied RF…
Thermal rectification is observed in jointless Pb wires at temperatures near the superconducting transition of Pb under magnetic fields. Using different magnetic-field (H) response of temperature dependence of thermal conductivity…
Cold ions trapped in the vicinity of conductive surfaces experience heating of their oscillatory motion. Typically, the rate of this heating is orders of magnitude larger than expected from electric field fluctuations due to thermal motion…
Developing high power density electronics requires effective and highly reliable cooling techniques with low thermal resistance and high heat removal capacity. Loop heat pipes (LHPs) are one kind of two-phase heat transfer device which can…
We study the heat transport in filamentary RRAM nano-sized devices by comparing the accurate results of COMSOL modeling with simplified analytical models for two complementary mechanisms: one neglecting the radial heat transfer from the…
Silicon photonic ring resonator thermometers have been shown to provide temperature measurements with a 10 mK accuracy. In this work we identify and quantify the intrinsic on-chip impairments that may limit further improvement in…
We present measurements of the motional heating rate of a trapped ion at different trap frequencies and temperatures between $\sim$0.6 and 1.5 MHz and $\sim$4 and 295 K. Additionally, we examine the possible effect of adsorbed surface…
Objectives Studies that assess magnetic resonance imaging (MRI) induced radiofrequency (RF) heating of the tissue in the presence of an active electronic implant are mostly performed in horizontal, closed-bore scanners. Vertical, open-bore…
We have studied the thermal properties of atom chips consisting o high thermal conductivity Aluminum Nitride (AlN) substrates on which gold microwires are directly deposited. We have measured the heating of wires of several widths and with…
In many situations, the dual-purpose heater/thermometer wires used in the three-omega method, one of the most precise and sensitive techniques for measuring the thermal conductivity of thin films and interfaces, must include bends and…
The study examines the heating profile of hot solar transition region loops, particularly focusing on transient brightenings observed in IRIS 1400{\AA} slit-jaw images. The findings challenge the adequacy of simplistic, singular heating…
Heat dissipation issues are the emerging challenges in the field of flexible electronics. Thermal management of flexible electronics creates a demand for flexible materials with highly anisotropic thermal conductivity, which work as heat…
Single spot radiometers are widely used to estimate temperature of body heated by high temperature, specially blast furnace, glass fusion, boiler of power plant, and so on. In previous papers on single spot radiometer a heated body was…
Considering high-temperature heating, the equations of transient heat conduction model require an adaptation, i.e. the dependence of thermophysical parameters of the model on the temperature is to be identified for each specific material to…
We report heating rate measurements in a microfabricated gold-on-sapphire surface electrode ion trap with trapping height of approximately 240 micron. Using the Doppler recooling method, we characterize the trap heating rates over an…
In this paper, we report the first evidence of an enhancement of the heat transfer from a heated wire by an external turbulent flow of superfluid helium. We used a standard Pt-Rh hot-wire anemometer and overheat it up to 21 K in a…
We study heating of motional modes of a single ion and of extended ion crystals trapped in a linear radio frequency (rf) Paul trap with a precision of $\Delta \dot{\bar{n}} \approx 0.2 $ phonons s$^{-1}$. Single-ion axial and radial heating…
We present a simple experiment on thermal diffusion in metal rods that can be used to integrate computation into the advanced lab. An analytical solution exists for the transient heat conduction in an infinite rod with a delta function heat…
This is the report on new development of an automated precision load-based measurement setup for thermoelectric power of different types of samples in the temperature range 5 - 330 K. The problems in the old spring-based setup have been…
We study electronic transport through a one-dimensional, finite-length quantum wire of correlated electrons (Luttinger liquid) coupled at arbitrary position via tunnel barriers to two semi-infinite, one-dimensional as well as stripe-like…