相关论文: DC-DC Converters Optimization in Case of Large Var…

Dynamics and stability of average current control of DC-DC converters are analyzed by sampled-data modeling. Orbital stability is studied and it is found unrelated to the ripple size of the orbit. Compared with the averaged modeling, the…

Most modern control systems are switched, meaning they have continuous as well as discrete decision variables. Switched systems often have constraints called dwell-time constraints (e.g., cycling constraints in a heat pump) on the switching…

DC loads (such as computers, data centres, electric vehicle chargers, and LED lamps) and dc distributed energy resources (such as fuel cells, solar photovoltaics, and energy storages) are rapidly growing in electric power systems, so dc…

There are tradeoffs between current sharing among distributed resources and DC bus voltage stability when conventional droop control is used in DC microgrids. As current sharing approaches the setpoint, bus voltage deviation increases.…

Grid-connected power converters are ubiquitous in modern power systems, acting as grid interfaces of renewable energy sources, energy storage systems, electric vehicles, high-voltage DC systems, etc. Conventionally, power converters use…

This paper considers the problem of regulating a dynamical system to equilibria that are defined as solutions of an input- and state-constrained optimization problem. To solve this regulation task, we design a state feedback controller…

Solving the optimal power flow problem is one of the main objectives in electrical power systems analysis and design. The modern optimization algorithms such as the evolutionary algorithms are also adopted to solve this problem, especially…

In this paper, a new Volt/Var Control (VVC) scheme is proposed to facilitate the coordination between the conventional VVC devices and the new smart PV inverters to provide an effective voltage control on a system with high PV penetration.…

It is well-known that measuring the input voltage and current, as the feedforward and feedback terms, are vital for the controller design in the problem of power factor compensation of an AC-DC boost converter. Traditional adaptive…

In the last decades, the applications of power inverter increased rapidly. As a result, in spite of rectifier, an inverter with a high-power electronic oscillator has capability to convert direct current (DC) into alternating current (AC)…

To tackle the difficulties faced by both stochastic dynamic programming and scenario tree methods, we present some variational approach for numerical solution of stochastic optimal control problems. We consider two different interpretations…

E-powertrain of future electric vehicles could consist of energy generation units (e.g., fuel cells and photovoltaic modules), energy storage systems (e.g., batteries and supercapacitors), energy conversion units (e.g., bidirectional DC/DC…

This article proposes a proximal policy optimization (PPO)-based reinforcement learning (RL) approach for DC-DC boost converter control that is compared with traditional control methods. The performance of the PPO algorithm is evaluated…

A critical challenge in power conversion in electric vehicles is the efficient use of DC-DC buck converters that need to provide 12-V supply for load systems from 400/800-V batteries. This paper presents a literature review on the…

Decentralized methods for computing optimal real and reactive power setpoints for residential photovoltaic (PV) inverters are developed in this paper. It is known that conventional PV inverter controllers, which are designed to extract…

The field-circuit coupled simulation of switch-mode power converters with conventional time discretization is computationally expensive since very small time steps are needed to appropriately account for steep transients occurring inside…

This paper addresses the challenges of embedding common droop control characteristics in ac-dc power system steady-state simulation and optimization problems. We propose a smooth approximation methodology to construct differentiable…

In this paper, parallel interconnection of DC/DC converters is considered. For this topology of converters feeding a common load, it has been recently shown that dynamics related to voltage regulation can be completely separated from the…

The flexibility of multi-terminal AC-DC-AC converters connected in distribution networks can be increased by changing the sizes of the individual AC-DC converter stages and connecting the AC side of those converters to electromechanical…

The renewable energy is connected to the power grid through power electronic converters, which are lack of make the inertia of synchronous generator/machine (SM) be lost. The increasing penetration of renewable energy in power system…