相关论文: Sub-Nyquist Sampling OFDM Radar

We present a sub-Nyquist analog-to-digital converter of wideband inputs. Our circuit realizes the recently proposed modulated wideband converter, which is a flexible platform for sampling signals according to their actual bandwidth…

Next generation wireless communication technology long term evolution (LTE) has implemented orthogonal frequency division multiplexing (OFDM) technique as a strong candidate for radio access systems. It has several attributes such as…

Differential orthogonal frequency division multiplexing (OFDM) is practically attractive for underwater acoustic communications since it has the potential to obviate channel estimation. However, similar to coherent OFDM, it may suffer from…

Key parameters of analog-to-digital converters (ADCs) are their sampling rate and dynamic range. Power consumption and cost of an ADC are directly proportional to the sampling rate; hence, it is desirable to keep it as low as possible. The…

In the past few years, new approaches to radar signal processing have been introduced which allow the radar to perform signal detection and parameter estimation from much fewer measurements than that required by Nyquist sampling. These…

Orthogonal frequency division multiplexing (OFDM) signals with rectangularly windowed pulses exhibit low spectral confinement. Two approaches usually referred to as pulse-shaping and active interference cancellation (AIC) are classically…

This paper proposes a simple multi-cycle cyclostationary based signal detection (spectrum sensing) algorithm for Orthogonal Frequency Division Multiplexed (OFDM) signals in cognitive radio networks. We assume that the noise samples are…

L-band Digital Aeronautical Communication System (LDACS) aims to exploit vacant spectrum in L-band via spectrum sharing, and orthogonal frequency division multiplexing (OFDM) is the currently accepted LDACS waveform. Recently, various works…

In this paper, we propose a deep learning-based signal detector called DuaIM-3DNet for dual-mode index modulation-based three-dimensional (3D) orthogonal frequency division multiplexing (DM-IM-3D-OFDM). Herein, DM-IM-3D- OFDM is a…

This paper considers a reconfigurable intelligent surface (RIS) aided orthogonal frequency division multiplexing (OFDM) relaying system, and investigates the joint design of RIS passive beamforming and subcarrier matching under two cases,…

Analog to digital converters (ADCs) act as a bridge between the analog and digital domains. Two important attributes of any ADC are sampling rate and its dynamic range. For bandlimited signals, the sampling should be above the Nyquist rate.…

In this paper, we propose a practical receiver for multicarrier signals subjected to a strong memoryless nonlinearity. The receiver design is based on a generalized approximate message passing (GAMP) framework, and this allows real-time…

Combined with space-time coding, the orthogonal frequency division multiplexing (OFDM) system explores space diversity. It is a potential scheme to offer spectral efficiency and robust high data rate transmissions over frequency-selective…

Channel state information (CSI) is essential to the performance optimization of intelligent reflecting surface (IRS)-aided wireless communication systems. However, the passive and frequency-flat reflection of IRS, as well as the…

Due to its time-varying nature, oscillator phase noise can significantly degrade the performance of channel estimation, carrier recovery, and data detection blocks in high-speed wireless communication systems. In this paper, we analyze…

In this letter, following a cross-layer design concept, we propose a novel subcarrier grouping technique for Orthogonal Frequency and Code Division Multiplexing (OFCDM) multiuser systems. We adopt a two dimensional (2D) spreading, so as to…

Herein, an atomic norm based method for accurately estimating the location and orientation of a target from millimeter-wave multi-input-multi-output (MIMO) orthogonal frequency-division multiplexing (OFDM) signals is presented. A novel…

This paper investigates a reconfigurable intelligent surface (RIS)-aided wideband massive multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) system with low-resolution analog-to-digital converters…

Millimeter-wave (mmWave) technology is a crucial enabler for next-generation networks because it offers substantially greater available bandwidth. mmWave multiple-input multiple-output (MIMO) systems cannot rely solely on fully digital…

Signal clipping is a classic technique for reducing peak-to-average power ratio (PAPR) in orthogonal frequency division multiplexing (OFDM) systems. It has been widely applied in consumer electronic devices owing to its low complexity and…