相关论文: Voltage deficit in solar cells with suppressed rec…
Passivated, hole-selective contacts play important role in reducing surface recombination by lowering the concentration of electrons in the rear side of a solar cell. However, parasitic optical losses in these contacts can still limit the…
Sub-bandgap reflectors (SBR) can reduce the temperature of photovoltaic (PV) modules by reflecting the near-infrared region of the solar spectrum with photon energies smaller than the electronic bandgap of the solar cell absorber material.…
Photon impingement is capable of liberating electrons in semiconductors. When the electron transport is primarily governed by temperature gradients, high irreversibilities will result, thus lowering converters' efficiencies. A fundamental…
We observe a strong peak in the capacitive photocurrent of a MDMO-PPV / PCBM bulk heterojunction solar cell for excitation below the absorbance threshold energy. Illumination at the peak energy blocks charge capture at other wavelengths,…
Copper indium disulfide (CuInS$_2$) grown under Cu-rich conditions exhibits high optical quality but suffers predominantly from charge carrier interface recombination resulting in poor solar cell performance. An unfavorable cliff like…
The radiative recombination, Shokley-Read recombination, frontal-surface and rear-surface recombination and the recombination at the heterojunction boundaries and the recombination in the space charge region are considered in the…
We have investigated how the relative elemental abundances inferred from the solar upper atmosphere are affected by uncertainties in the dielectronic recombination (DR) rate coefficients used to analyze the spectra. We find that the…
While the basic principles and limitations of conventional solar cells are well understood, relatively little attention has gone toward maximizing the potential efficiency of photovoltaic devices based on shift currents. In this work, we…
Unintentional doping of the active layer is a source for lowered device performance in organic solar cells. The effect of doping is to induce a space-charge region within the active layer, generally resulting in increased recombination…
Moisture- and temperature-activated corrosion of metal fingers, mechanical stress induced delamination, and failure of solder bonds rank among the leading failure mechanisms of solar modules. The physics of moisture ingress, diffusion and…
We obtain theoretical expressions for the photocurrent in the Heterojunction solar cells with Intrinsic Thin layer (HIT cells). Our calculations take into account tunneling of electrons and holes through wide-bandgap layers of $\alpha$-Si:H…
Here, we report an experimental demonstration of perovskite solar cells dominated by bimolecular recombination and critically analyse their performance against radiative limits. To this end, we first establish a set of quantitative…
The understanding and optimization of solar energy conversion and light emitting devices can greatly benefit from equivalent circuit models describing their response. However, a general model of electron-hole recombination in semiconductors…
The radiative recombination of electron-hole pairs represents a great challenge to the photon-to-charge efficiency in the photocell. In this paper, we investigate how to suppress radiative recombination rate (RRR) in a proposed quantum…
CdTe is a key thin-film photovoltaic technology. Non-radiative electron-hole recombination reduces the solar conversion efficiency from an ideal value of 32% to a current champion performance of 22%. The cadmium vacancy (V_Cd) is a…
Low open circuit voltage ($V_{OC}$) has been recognized as the number one problem in the current generation of Cu$_{2}$ZnSn(Se,S)$_{4}$ (CZTSSe) solar cells. We report high light intensity and low temperature Suns-$V_{OC}$ measurement in…
Photogalvanic solar cells, the original dye based solar cell, have yet to fulfill their promise as a low fabrication cost, scalable energy conversion system. The efficient performance of photogalvanic cells relies on high dye solubility and…
Organic solar cells (OSCs) have recently shown a rapid improvement in their performance, bringing power conversion efficiencies (PCEs) closer to the point where commercial applications of the technology become viable. However, the low…
Multiple exciton generation solar cells exhibit a low power conversion efficiency owing to nonradiative recombination even if numerous electron and hole pairs are generated per incident photon. This paper elucidates the non-idealities of…
A theoretical approach to photoconversion efficiency modeling in perovskite p-i-n structures is developed. The results of this modeling compare favorably with the experiment and indicate that the surfaces of the perovskite solar cells (SCs)…