相关论文: Wavelet Packet Division Multiplexing (WPDM)-Aided …

The information transmission between nodes in a wireless sensor networks (WSNs) often causes packet loss due to denial-of-service (DoS) attack, energy limitations, and environmental factors, and the information that is successfully…

In this paper, a cooperative diffusion-based molecular communication system is considered where distributed receivers collaboratively determine a transmitter's signal. In this system, the receivers first make local hard decisions about the…

The integrated sensing and communications (ISAC) can achieve the sharing of hardware and spectrum resources, enabling efficient data transmission and environmental sensing. This fusion is particularly important for unmanned aerial vehicle…

The design of sensor networks capable of reaching a consensus on a globally optimal decision test, without the need for a fusion center, is a problem that has received considerable attention in the last years. Many consensus algorithms have…

In this letter, we propose space-time spreading (STS) of local sensor decisions before reporting them over a wireless multiple access channel (MAC), in order to achieve flexible balance between diversity and multiplexing gain as well as…

Random access schemes are widely used in IoT wireless access networks to accommodate simplicity and power consumption constraints. As a result, the interference arising from overlapping IoT transmissions is a significant issue in such…

The integrated sensing and communication (ISAC) has been envisioned as one representative usage scenario of sixth-generation (6G) network. However, the unprecedented characteristics of 6G, especially the doubly dispersive channel, make…

The paper studies optimal sensor selection for source estimation in energy harvesting Internet of Things (IoT) networks. Specifically, the focus is on the selection of the sensor locations which minimizes the estimation error at a fusion…

A wireless sensor network often relies on a fusion center to process the data collected by each of its sensing nodes. Such an approach relies on the continuous transmission of raw data to the fusion center, which typically has a major…

The omnipresence of IoT devices in Industry 4.0 is expected to foster higher reliability, safety, and efficiency. However, interconnecting a large number of wireless devices without jeopardizing the system performance proves challenging. To…

This paper considers the transmitter design for wireless information and energy transfer (WIET) in a multiple-input single-output (MISO) interference channel (IFC). The design problem is to maximize the system throughput (i.e., the weighted…

Traditional physical layer secure beamforming is achieved via precoding before signal transmission using channel state information (CSI). However, imperfect CSI will compromise the performance with imperfect beamforming and potential…

Integrated sensing and communication (ISAC) is a key enabler of 6G. Unlike communication radio links, the sensing signal requires to experience round trips from many scatters. Therefore, sensing is more power-sensitive and faces a severer…

In this paper, we investigate the downlink communication challenges in heavy-load Internet-of-Things (IoT) networks supported by frequency-division-duplexing (FDD) millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO)…

Most Internet of Things (IoT) network simulators are packet-level discrete-event systems in which physical-layer (PHY) behavior is approximated through analytical interference rules and precomputed error models. While this enables scalable…

The ongoing convergence of spectrum and hardware requirements for wireless sensing and communication applications has fueled the integrated sensing and communication (ISAC) paradigm in next-generation networks. Neural-network-based ISAC…

Windowed orthogonal frequency-division multiplexing (OFDM) and wavelet OFDM have been proposed as medium access techniques for broadband communications over the power line network by the standard IEEE 1901. Windowed OFDM has been…

The Industrial Internet of Things (IIoT) is a developing research area with potential global Internet connectivity, turning everyday objects into intelligent devices with more autonomous activities. IIoT services and applications are not…

In this paper, we propose a novel design for the rotary-wing unmanned aerial vehicle (UAV)-enabled full-duplex (FD) wireless-powered Internet of Things (IoT) networks. In this network, the UAV is equipped with an antenna array, and the $K$…

A central use case for the Internet of Things (IoT) is the adoption of sensors to monitor physical processes, such as the environment and industrial manufacturing processes, where they provide data for predictive maintenance, anomaly…