相关论文: Model for Photoresponsive Nematic Elastomers
We consider models for elastic liquids, such as solutions of flexible polymers. They introduce a relaxation time $\lambda$ into the system, over which stresses relax. We study the kinematics of the problem, and clarify the relationship…
This paper is concerned with the output feedback exponential stabilization for a flexible beam with tip mass. When there is no disturbance, it is shown that only one non-collocated measurement is enough to exponentially stabilize the…
Predicting the macroscopic mechanical behavior of polymeric materials from the micro-structural features has remained a challenge for decades. Existing theoretical models often fail to accurately capture the experimental data, due to…
We report on the demonstration of an effective, nonlinearity-induced non-reciprocal behavior in a single non-magnetic multi-mode Taiji resonator. Non-reciprocity is achieved by a combination of an intensity-dependent refractive index and of…
The size-dependent electrical resistivity of single-layer graphene ribbons has been studied experimentally for ribbon widths from 16 nm to 320 nm. The experimental findings are that the resistivity follows a more dramatic trend than that…
We consider the statistics of density number of filaments for the propagation of a laser beam subjected to multiple filamentation in a closed area with reflecting boundaries. Dissipation arrests the catastrophic collapse of filaments,…
We uncover how nonlinearities dramatically alter the buckling of elastic beams. First, we show experimentally that sufficiently wide ordinary elastic beams and specifically designed metabeams ---beams made from a mechanical metamaterial---…
An elastic anomaly, observed in the heavy fermi liquid state of Ce alloys (for example, CeCu$_6$ and CeTe), is analyzed by using the infinite-$U$ Anderson lattice model. The four atomic energy levels are assumed for f-electrons. Two of them…
An elastic anomaly, observed in the heavy fermi liquid state of Ce alloys (for example, CeCu$_6$ and CeTe), is analyzed by using the infinite-$U$ Anderson lattice model. The four atomic energy levels are assumed for f-electrons. Two of them…
In this work a new mechanics will be studied which is based on the hypothesis that the change of linear momentum of a particle happens as a discrete pulses. By using this hypothesis and by considering Newton's relation between energy and…
The photoisomerization reaction of the retinal chromophore in rhodopsin was computationally studied using a two-state two-mode model coupled to thermal baths. Reaction quantum yields at the steady state (10 ps and beyond) were found to be…
We study the deformation and slip-through of a heavy elastic beam suspended above two point supports and subject to an increasing body force -- an idealized model of a fibre trapped in the pores of a filter as flow strength increases, for…
Polymeric materials that couple deformation and electrostatics have the potential for use in soft sensors and actuators with potential applications ranging from robotic, biomedical, energy, aerospace and automotive technologies. In contrast…
The peeling of an immobile adsorbed membrane is a well known problem in engineering and macroscopic tribology. In the classic setup, picking up at one extreme and pulling off results in a peeling force that is a decreasing function of the…
Instabilities in thin elastic sheets, such as wrinkles, are of broad interest both from a fundamental viewpoint and also because of their potential for engineering applications. Nematic liquid crystal elastomers offer a new form of control…
Examining phototactic bioconvection in non-scattering suspensions with upper heating and collimated irradiation, this study delves into the intricate dynamics influenced by light and microorganisms. The study focuses on the linear stability…
We address the problem of active optical steering of structural phase transitions in solids. We demonstrate that existing reinforcement learning approaches can derive optimal time-dependent electric fields in optically-driven dissipative…
A pinned-free beam in axial fluid flow, subjected to feedback-based actuation at the pinned end, is investigated. The actuation may be a moment or a prescribed angle and it is proportional to the state (curvature, slope, or displacement) of…
In this paper we consider a viscoelastic string whose deformation is controlled at one end. We study the relations and the controllability of the couples traction/velocity and traction/deformation and we show that the first couple behaves…
The classical flexure problem of non-linear incompressible elasticity is revisited assuming that the bending angle suffered by the block is specified instead of the usual applied moment. The general moment-bending angle relationship is then…