相关论文: Failure Mode Analysis in Microsecond UV Laser Anne…
Elemental selenium is a promising wide-bandgap ($E_\mathrm{G}\approx$ 1.95 eV) photovoltaic material for the next generation of thin-film solar cells. To realize high-efficiency selenium solar cells, it is crucial to optimize the…
Microcompression testing is used to probe the uniaxial stress-strain response of a nanocrystalline alloy, with an emphasis on exploring how grain size and grain boundary relaxation state impact the complete flow curve and failure behavior.…
Scattering induced mode splitting in active microcavities is demonstrated. Below the lasing threshold, quality factor enhancement by optical gain allows resolving, in the wavelength-scanning transmission spectrum, the resonance dips of the…
We propose to realize microwave quantum illumination in weak coupling regime based on multimode optomechanical systems. In our proposal the multimode together with a frequency-mismatch process could reduce mechanical thermal noise.…
We propose and demonstrate a spatial partition method for the high-frequency photo-response of superconducting devices correlated with inductive and resistive changes in microwave impedance. Using a laser scanning microscope, we show that…
A laser scanning microscope with a thermal spot size of about 4 $\mu$m is used to measure a quantity proportional to the rf current density in an operating superconducting co-planar waveguide microwave resonator. The twinning of the…
Growth, electronic and magnetic properties of $\gamma'$-Fe$_{4}$N atomic layers on Cu(001) are studied by scanning tunneling microscopy/spectroscopy and x-ray absorption spectroscopy/magnetic circular dichroism. A continuous film of ordered…
Mitigating the RC delay from transistor miniaturization is essential for next-generation devices, driving a focus on interconnect electrical performance. Current copper-based interconnects face a critical challenge, that their resistivity…
For semiconductor device fabrication, Pulsed Laser Annealing (PLA) offers significant advantages over conventional thermal processes. Notably, it can provide ultrafast (~ns) and high temperature profiles ($>1000^\circ$C). When the maximum…
To rectify the problems of electron clouds observed in RHIC and unacceptable ohmic heating for superconducting magnets that can limit future machine upgrades, we started developing a robotic plasma deposition technique for $in-situ$ coating…
We present a simulation capability for micro-scale light-emitting diodes (uLEDs) that achieves comparable accuracy to CPU-based finite-difference time-domain simulation but is more than 10^7 times faster. Our approach is based on the…
A Li-Al-O thin film materials library, deposited by inert magnetron sputtering and post-deposition annealing in O2 atmosphere, was used to study the effects of different annealing temperatures (300 to 850{\deg}C) and durations (1 min to 7…
Laue lenses are an emerging technology that will enhance gamma-ray telescope sensitivity by one to two orders of magnitude in selected energy bands of the \sim 100 keV to \sim 1.5 MeV range. This optic would be particularly well adapted to…
The thermal response of a Cu-Ti double-layered film is investigated after laser irradiation with ultrashort pulses (pulse duration {\tau}p=50fs, 800nm laser wavelength) in submelting conditions by including the influence of nonthermal…
Using a ceramic thermoelectric heater, we show highly reproducible fabrication of single-mode sub-wavelength silica tapers with ultra-low loss level. The reproducibility of the process is studied statistically, leading to an average taper…
We describe the use of a near-field scanning microwave microscope to quantitatively image the dielectric permittivity and tunability of thin-film dielectric samples on a length scale of 1 micron. We demonstrate this technique with…
Particle accelerators represent an indispensable tool in science and industry. However, the size and cost of conventional radio-frequency accelerators limit the utility and reach of this technology. Dielectric laser accelerators (DLAs)…
We present an undergraduate lab that investigates weak localization in thin silver films. The films prepared in our lab have thickness, $a$, between 60-200 \AA, a mesoscopic length scale. At low temperatures, the inelastic dephasing length…
The control of large-scale quantum information processors based on arrays of trapped ions requires a means to route and focus multiple laser beams to each of many trapping sites in parallel. Here, we combine arrays of fibres, 3D…
Thin films of undoped zinc oxide (ZnO) and doped ZnO with copper were deposited on ceramic pellets made from abundant local clay materials with an addition of zirconia (ZrO2). The thin layers were prepared by a thermal method using an…