相关论文: Reducing strain in heterogeneous quantum devices u…
Transition metal (TM) defects in silicon carbide (SiC) are a promising platform for applications in quantum technology as some of these defects, e.g. vanadium (V), allow for optical emission in one of the telecom bands. For other defects it…
We propose a novel class of temperature-tunable semiconductor metamaterials that exhibit negative refraction in the terahertz spectral range. These metamaterials are based on doped semiconductor superlattices with ultrathin barriers of…
Atomic arrays can exhibit collective light emission when the transition wavelength exceeds their lattice spacing. Subradiant states take advantage of this phenomenon to drastically reduce their overall decay rate, allowing for long-lived…
One of the most promising building blocks for the development of spin qubits, single-photon sources, and quantum sensors at room temperature, as well as 2D ultraviolet light-emitting diodes, are defect colour centres in 2D hexagonal boron…
Thin aluminum oxide films were deposited by a new and simple physicochemical method called chemical liquid phase deposition (CLD) on semiconductor materials. Aluminum sulfate with crystallized water and sodium bicarbonate were used as…
A series of density functional theory (DFT) simulations was performed to investigate the approach, contact, and subsequent separation of two atomically flat surfaces consisting of different materials. Aluminum (Al) and titanium nitride…
To study the size and strain rate dependency of copper polycrystalline microstructures, a multi-layered copper/Al$_2$O$_3$ thin film was deposited on a Si substrate using a hybrid deposition system (combining physical vapour and atomic…
Transition metal dichalcogenides (TMD) monolayers, holding potential as good sunlight absorbers, are promising materials for next-generation optoelectronic devices. They may enable ultrathin photovoltaic(PV) devices thanks to their…
The deposition of a thin oxide layer at metal/semiconductor interfaces has been previously reported as a means of reducing contact resistance in 2D electronics. Using X-ray photoelectron spectroscopy with in-situ Ti deposition, we fabricate…
The established approach to laser cooling of solids relies on anti-Stokes fluorescence, for example from rare earth impurities in glass. Although successful, there is a minimum temperature to which such a process can cool set by the…
Plasmonic excitations behave fundamentally different in layered materials in comparison to bulk systems. They form gapless modes, which in turn couple at low energies to the electrons. Thereby they can strongly influence superconducting…
Relaxation of electronic spins in metals is significantly enhanced whenever a Fermi surface crosses Brillouin zone boundaries, special symmetry points, or lines of accidental degeneracy. A realistic calculation shows that if aluminum had…
Altermagnets (AMs) are an emergent class of magnetic materials that combine properties of ferromagnets and antiferromagnets, exhibiting spin-polarized Fermi surfaces and zero net magnetic moment due to combined time-reversal and crystal…
Atomic modulations of two-dimensional materials using scanning tunneling microscope (STM) tip-induced forces modifies their mechanical and electrical properties. In situ topographic and spectroscopic probing through electrical tunneling has…
A new class of phenomena stemming from topological states of quantum matter has recently found a variety of analogies in classical systems. Spin-locking and one-way propagation have been shown to drastically alter our view on scattering of…
The effect of screening of the coulomb interaction between two layers of two-dimensional electrons, such as in graphene, by a highly doped semiconducting substrate is investigated. We employ the random-phase approximation to calculate the…
Latent Diffusion Models (LDMs) are known to have an unstable generation process, where even small perturbations or shifts in the input noise can lead to significantly different outputs. This hinders their applicability in applications…
Microwave loss in superconducting titanium nitride (TiN) films is attributed to two-level systems in various interfaces arising in part from oxidation and microfabrication-induced damage. Atomic layer etching (ALE) is an emerging…
We grow AlN/4H-SiC and AlN/6H-SiC heterostructures by physical vapor deposition and characterize the heterointerface with nanoscale resolution. Furthermore, we investigate the spatial stress and strain distribution in these heterostructures…
We present an efficient method for subrecoil cooling of neutral atoms by applying Raman cooling in 2D to a four-level tripod-system. The atoms can be cooled simultaneously in two directions using only three laser beams. We describe the…