相关论文: Comparing spontaneous and pellet-triggered ELMs vi…

Small edge-localized-mode (ELM), similar to the quasi-continuous exhaust (QCE), has been achieved by increasing the density at the separatrix. Starting from the Type-I ELM experimental data in EAST, we have performed a numerical separatrix…

Shattered pellet injection (SPI) is selected for the disruption mitigation system in ITER, due to deeper penetration, expected assimilation efficiency and prompt material delivery. This article describes non-linear magnetohydrodynamic (MHD)…

An analytic theory of edge localized mode (ELM) suppression in an H-mode tokamak plasma via the application of a static, externally generated, resonant magnetic perturbation (RMP) is presented. This theory is based on the plausible…

H-mode operation of tokamak fusion plasmas free of dangerous Type 1 edge-localized-modes (ELMs) requires a non-ELM mechanism for saturating the edge pedestal growth. One possible mechanism is turbulent transport. We introduce a transport…

The BOUT++ code is used to simulate ELMs in a shifted circle equilibrium. Reduced ideal MHD simulations are first benchmarked against the linear ideal MHD code ELITE, showing good agreement. Diamagnetic drift effects are included finding…

Several analysis methods for nonstationary fluctuations are described and applied to the edge localized mode (ELM) instabilities of limiter H-mode plasmas. The microwave scattering diagnostic observes poloidal $k_{\theta}$ values of 3.3…

Edge localised modes (ELMs) allow maintaining sufficient purity of tokamak H-mode plasmas and thus enable stationary H-mode. On the other hand in a future device ELMs may cause divertor power flux densities far in excess of tolerable…

Resonant magnetic perturbations (RMPs) can mitigate the edge-localized modes (ELMs), i.e. cause a change of the ELM character towards smaller energy loss and higher frequency. During mitigation a change of the spatial structure of ELM loads…

Edge localised mode (ELM) measurements from reproducibly similar plasmas in the Joint European Torus (JET) tokamak, which differ only in their gas puffing rate, are analysed in terms of the pattern in the sequence of inter-ELM time…

In this letter, it is reported that the first experimental results are associated with the GAM induced by energetic electrons (eEGAM) in HL-2A Ohmic plasma. The energetic-electrons are generated by parallel electric fields during magnetic…

A direct numerical simulation model for the rocket acceleration of pellets in thermonuclear fusion devices has been developed for PELOTON, a 3D Lagrangian particle pellet code [R. Samulyak et al, Nuclear Fusion 61 (4), 046007 (2021)], and…

JOREK 3D non-linear MagnetoHydroDynamic (MHD) simulations of pure Deuterium Shattered Pellet Injection in ITER are presented. It is shown that such a scheme could allow diluting the plasma by more than a factor 10 without immediately…

The rapid deposition of energy by Edge Localised Modes (ELMs) onto plasma facing components, is a potentially serious issue for large Tokamaks such as ITER and DEMO. The trigger for ELMs is believed to be the ideal Magnetohydrodynamic…

Three dimensional electromagnetic gyrofluid simulations of the ideal ballooning mode blowout scenario for tokamak edge localized modes (ELMs) are presented. Special emphasis is placed on energetic diagnosis, examining changes in the growth…

Enhanced $D_{\alpha}$ H-mode (EDA H-mode), an ELM-free H-mode regime, is explored in neutral beam heated, lower single null plasmas with near zero torque injection. This regime exhibits a good energy confinement…

The theoretical investigation of relevant turbulent transport mechanisms in H-mode pedestals is a great scientific and numerical challenge. In this study, we address this challenge by global, nonlinear gyrokinetic simulations of a full…

The free-streaming plus recycling model (FSRM) has recently been developed to understand and predict tungsten gross erosion rates from the divertor during edge localized modes (ELMs). In this work, the FSRM was tested against experimental…

Experimental measurements of plasma and neutral profiles across the pedestal are used in conjunction with 2D edge modeling to examine pedestal stiffness in Alcator C-Mod H-mode plasmas. Experiments on Alcator C-Mod observed pedestal…

The transition between the ELMy H-mode and the EDA H-mode is studied on Alcator C-Mod using an experimental database and predictive pedestal models. High-resolution Thomson scattering measurements are used to compare the pedestal density,…

Toroidal flow alone is generally thought to have important influence on tokamak edge pedestal stability, even though theory analysis often predicts merely a weak stabilizing effect of toroidal flow on the edge localized modes (ELMs) in…