相关论文: A Three-step Model for Optimizing Coil Spacings In…
The distance between the last closed flux surface (LCFS) and the nearest electromagnetic coils is a dominating factor in the cost, size, and engineering difficulty of stellarators. The smallest magnetic gradient scale length on the LCFS -…
Designing magnets for three-dimensional plasma confinement is a key task for advancing the stellarator as a fusion reactor concept. Stellarator magnets must produce an accurate field while leaving adequate room for other components and…
This review article describes the performance of the magnetic field measuring and monitoring systems for the Compact Muon Solenoid (CMS) detector. To cross-check the magnetic flux distribution obtained with the CMS magnet model, four…
The magnetic field noise in superconducting quantum interference devices (SQUIDs) used for biomagnetic research such as magnetoencephalography or ultra-low-field nuclear magnetic resonance is usually limited by instrumental dewar noise. We…
High-permeability magnetic shields generate magnetic field noise that can limit the sensitivity of modern precision measurements. We show that calculations based on the fluctuation-dissipation theorem allow quantitative evaluation of…
A compact Halbach array magnet is used to measure the momentum of the secondary particles in EMPHATIC (Experiment to Measure the Production of Hadrons At a Test beam In Chicagoland). Hall probe data was taken for the central cylindrical…
Numerical simulations of the propagation of charged particles through magnetic fields solving the equation of motion often leads to the usage of an interpolation in case of discretely defined magnetic fields, typically given on a…
QU-fitting is a standard model-fitting method to reconstruct distribution of magnetic fields and polarized intensity along a line of sight (LOS) from an observed polarization spectrum. In this paper, we examine the performance of QU-fitting…
Highly sophisticated synthesis methods and experimental techniques allow for precise measurements of magnetic properties of nanoparticles that can be reliably reproduced using theoretical models. Here, we investigate the magnetic properties…
The design of divertor targets and baffles for optimal heat and particle exhaust from magnetically confined fusion plasmas requires a combination of fast, low-fidelity models (such as EMC3-lite [1]) for scoping studies and high-fidelity…
Magnetic field extrapolation is a fundamental tool to reconstruct the three-dimensional magnetic field above the solar photosphere. However, the prevalently used force-free field model might not be applicable in the lower atmosphere with…
A passive superconducting shield was proposed earlier to realize a high-field (3-4 T) septum magnet for the Future Circular Collider. This paper presents the experimental results of a potential shield material, a NbTi/Nb/Cu multilayer…
The simulation of large-scale high-temperature superconducting (HTS) magnets is a computational challenge due to the multiple spatial scales involved, from the magnet to the detailed turn-to-turn geometry. To reduce the computational cost…
We present a novel Active Magnetic Shield (AMS), designed and implemented for the n2EDM experiment at the Paul Scherrer Institute. The experiment will perform a high-sensitivity search for the electric dipole moment of the neutron.…
Background: Calculation of the electric field induced by transcranial magnetic stimulation (TMS) in the brain requires accurate models of the stimulation coils. Reconstructing models from the measured magnetic fields of coils so far worked…
Phase coexistence across disorder-broadened and magnetic-field-induced first order antiferromagnetic to ferrimagnetic transition in polycrystalline $Mn_{1.85}Co_{0.15}Sb$ has been studied mesoscopically by Scanning Hall Probe Microscope at…
Performance of triple GEM prototypes in strong magnetic field has been evaluated bymeans of a muon beam at the H4 line of the SPS test area at CERN. Data have been reconstructedand analyzed offline with two reconstruction methods: the…
The improvement of accelerator parameters requires the transition to superconducting undulator technologies since SCUs allow higher magnetic fields compared to classical planar undulators with the same gap. The primary method for…
In fusion reactor design, steels under consideration for the blanket are ferromagnetic, so the steel's effect on the plasma physics must be examined. For efficient calculation of these fields, we can exploit the fact that the magnetic…
We demonstrate a fully automated open-source magnetometer designed primarily for characterization of magnetic fields produced by coils, permanent magnets or by parasitic sources. It is based on an Arduino Mega microcontroller and a…