相关论文: Oxygen-based digital etching of AlGaN/GaN structur…

The investigation of small size embedded nanostructures, by a combination of complementary anomalous diffraction techniques, is reported. GaN Quantum Dots (QDs), grown by molecular beam epitaxy in a modified Stranski-Krastanow mode, are…

In this paper we present a reliable process to fabricate GaN/AlGaN one dimensional photonic crystal (1D-PhC) microcavities with nonlinear optical properties. We used a heterostructure with a GaN layer embedded between two Distributed Bragg…

Graphene-based sponges doped with atomic nitrogen and boron were applied for the electrochemical degradation of persistent organic contaminants in one-pass, flow-through mode, and in a low-conductivity supporting electrolyte. The B-doped…

We investigate the surface flashover voltage threshold for SiO$_2$, SiN, and AlN thin films over micrometre scale lengths. Furthermore, we test the effects of different etching chemistries on SiO$_2$ layers. We find that there is little…

Beta gallium oxide ($\beta$-Ga$_2$O$_3$) shows significant promise in the high-temperature, high-power, and sensing electronics applications. However, long-term stable metallization layers for Ohmic contacts at high temperature present…

Thermal boundary resistance (TBR) in semiconductor-on-diamond structure bottlenecks efficient heat dissipation in electronic devices. In this study, to reduce the TBR between GaN and diamond, surface-activated bonding with a hybrid SiOx-Ar…

Series of GaN/AlN superlattices (SLs) with various periods and the same thicknesses of GaN quantum wells and AlN barriers have been investigated. X-ray diffraction, photoluminescence (PL) and transmission electron microscopy (TEM)…

The three dimensional carrier confinement in GaN nanodiscs embedded in GaN/AlGaN nanowires and its effect on their photoluminescence properties is analyzed for Al concentrations between x = 0.08 and 1. Structural analysis by high resolution…

Better wall plug efficiency of deep-ultraviolet light emitting diodes (DUV-LEDs) requires simultaneous low resistivity p-type and n-type contacts, which is a challenging problem. In this study, the co-optimization of p-InGaN and n- AlGaN…

This work presents a new acoustic MEMS resonator technology, dubbed Aluminum Nitride (AlN) Combined Overtone Resonator (COR), capable of addressing the filter requirements for the 5G mmWave spectrum in the 6-40GHz range. The COR exploits…

Due to the piezoelectric nature of GaN, the 2DEG in AlGaN/GaN HEMT could be engineered by strain. In this work, SiNx deposited using dual-frequency PECVD was used as a stressor. The output performance of the devices was dominated by the…

Ultraviolet nanosecond laser annealing (UV-NLA) proves to be an important technique, particularly when tightly controlled heating and melting are necessary. In the realm of semiconductor technologies, the significance of nanosecond laser…

Atom probe tomography (APT), electron probe microanalysis (EPMA) and nanoindentation were used to characterise the oxygen-rich layer on an in-service jet engine compressor disc, manufactured from the titanium alloy TIMETAL 834. Oxygen…

The Al-Ga intermixing at Al(Ga)N/GaN interfaces in nanowires and the chemical inhomogeneity in AlxGa1-xN/AlN nanodisks (NDs) are attributed to the strain relaxation process. This interpretation is supported by the three-dimensional strain…

Atomic layer deposition (ALD) is a key technique for the continued scaling of semiconductor devices, which increasingly relies on reproducible and scalable processes for interface manipulation of 3D structured surfaces on the atomic scale.…

We have reproducibly grown near-single-domain superconducting aluminum (Al) films on GaAs(111)A wafers using molecular beam epitaxy. Synchrotron X-ray diffraction revealed twin-domain ratios of 0.00005 and 0.0003 for 19.4-nm- and…

The effect of hydrogenation on the topography and the electronic properties of graphene and graphite surfaces are studied by scanning tunneling microscopy and spectroscopy. The surfaces are chemically modified using Ar/H2 plasma. Analyzing…

Lithium niobate (LiNbO$_3$, LN) is a ferroelectric crystal of interest for integrated photonics owing to its large second-order optical nonlinearity and the ability to impart periodic poling via an external electric field. However, on-chip…

We report the first observation of re-entrant layer-by-layer etching based on {\it in situ\/} reflection high-energy electron-diffraction measurements. With AsBr$_3$ used to etch GaAs(001), sustained specular-beam intensity oscillations are…

The p-type surface conductivity of H-terminated diamond (HD, H-diamond) has created new path ways for developing diamond based electronic devices as well as chemical and bio-sensors. However, the hydrophobic nature of the HD surface can…