相关论文: High-throughput extraction of the anisotropic inte…
The liquid-solid diffusion couple technique, supported by phenomenological analysis and nano-indentation tests, is proposed on account of the relatively low melting points of Mg to explore the diffusion mobility and creep deformation. The…
This paper presents a brief review on the reported anisotropic properties of MgB2, in the superconducting state (e.g. upper critical field Hc2, field penetration depth, coherence length, energy gap) as well as in the normal state (e.g.,…
The experimental data in the literature for the hcp phase of the Mg-Al-Zn ternary system have been critically reviewed. Based on the concentration profiles from the literature, the diffusion coefficients have been re-extracted using the…
The light elemental solutes B, C, N, and O can penetrate the surface of Mg alloys and diffuse during heat treatment or high temperature application, forming undesirable compounds. We investigate the diffusion of these solutes by determining…
Correlated analysis of (sub)grains and particles in alloys is important to understand transformation processes and control material properties. A multimodal data fusion workflow directly combining subgrain data from electron backscatter…
Mg grain boundary (GB) segregation and GB diffusion can impact the processing and properties of Al-Mg alloys. Yet, Mg GB diffusion in Al has not been measured experimentally or predicted by simulations. We apply atomistic computer…
This study elucidates the intriguing phenomenon of inverse thermal anisotropy in cadmium magnesium oxide (CdMgO) thin films, characterized by cross-plane thermal conductivity being greater than in-plane thermal conductivity, essential for…
In parallel with advances in microscale imaging techniques, the fields of biology and materials science have focused on precisely extracting particle properties based on their diffusion behavior. Although the majority of real-world…
The early stage of the reactive interdiffusion in the Cu-Al system was investigated at 350 {\textdegree}C and 300 {\textdegree}C thanks to in-situ transmission electron microscopy. A special care was given to find conditions where the…
The diffusion of silver (Ag) impurities in high energy grain boundaries (HEGBs) of cubic (3C) silicon carbide (SiC) is studied using an ab initio based kinetic Monte Carlo (kMC) model. This study assesses the hypothesis that the HEGB…
Impurity diffusion coefficients are entirely obtained from a low cost classical molecular statics technique (CMST). In particular, we show how the CMST is appropriate in order to describe the impurity diffusion behavior mediated by a…
We report high-resolution Compton profiles (CP's) of Al along the three principal symmetry directions at a photon energy of 59.38 keV, together with corresponding highly accurate theoretical profiles obtained within the local-density…
Estimating composition dependent diffusion coefficients in multicomponent alloys was a longstanding challenge due to limitations in experimental methods. In this study, we have first demonstrated a strategic design of producing only three…
The structures of epitaxial ultrathin Co2FeAl/MgO(001) heterostructures relating to the interface-induced perpendicular magnetic anisotropy (PMA) were investigated using scanning transmission electron microscopy, energy dispersive x-ray…
The lower ($H_{c1}$) and upper ($H_{c2}$) critical fields of Mg$_{1-x}$Al$_{x}$B$_2$ single crystals (for $x = 0$, 0.1 and $\gtrsim 0.2$) have been deduced from specific heat and local magnetization measurements, respectively. We show that…
Diffusion in ternary, multiphase systems was studied theoretically and experimentally in Ni-Cr-Al system at 1200C. The samples were prepared by the multiple method. It has been shown that the method allows obtaining good quality, planar,…
Slip transfer across grain boundaries was studied in annealed polycrystalline Al foils deformed in uniaxial tension by means of the analysis of the slip traces on the specimen surface. Grain orientations and selected grain boundary…
A set of thin film Mn$_x$Si$_{1-x}$ alloy samples with different manganese concentration x = 0.44 - 0.63 grown by the pulsed laser deposition (PLD) method onto the Al$_2$O$_3$(0001) substrate was investigated in the temperature range 4 -…
We describe a novel mechanism for the synthesis of a stable high-entropy alloy powder from an otherwise immiscible Mg-Ti rich metallic mixture by employing high-energy mechanical milling. The presented methodology expedites the synthesis of…
First-principles thermodynamic models based on the cluster expansion formalism, monte-carlo simulations and quantum-mechanical total energy calculations are employed to compute short-range-order parameters and diffuse-antiphase-boundary…