相关论文: A Simple Method for 5G Positioning and Synchroniza…
We consider the problem of estimating the 3D orientation of a user, using the downlink mmWave signals received from multiple base stations. We show that the received signals from several base stations, having known positions, can be used to…
Reconfigurable intelligent surfaces (RISs) have attracted enormous interest thanks to their ability to overcome line-of-sight blockages in mmWave systems, enabling in turn accurate localization with minimal infrastructure. Less investigated…
Publicly available satellite imagery can be an ubiquitous, cheap, and powerful tool for vehicle localisation when a prior sensor map is unavailable. However, satellite images are not directly comparable to data from ground range sensors…
The sensitivity of millimeter wave (mmWave) signals to blockages is a fundamental challenge for mobile mmWave communication systems. The sudden blockage of the line-of-sight (LOS) link between the base station and the mobile user normally…
The use of higher frequencies and MIMO is important in many 5G use cases. However, the available channel models for millimeter waves (mmWaves) currently demand investigation and the number of measurements is still limited. Using simulators…
3GPP release 15 focusing on 5G general outline has been published in December 2017. The major difference with respect to currently deployed LTE is the support of various physical layer numerologies. Making the physical layer scalable allows…
Perfect alignment in chosen beam sectors at both transmit- and receive-nodes is required for beamforming in mmWave bands. Current 802.11ad WiFi and emerging 5G cellular standards spend up to several milliseconds exploring different sector…
MmWave communications, one of the cornerstones of future 5G mobile networks, are characterized at the same time by a potential multi-gigabit capacity and by a very dynamic channel, sensitive to blockage, wide fluctuations in the received…
This paper focuses at the investigation of the degree of orthogonality of channels of multiple users in densely populated indoor and outdoor scenarios. For this purpose, a statistical millimeter wave (mmwave) MIMO channel simulator is…
The millimeter wave (mmWave) bands and other high frequencies above 6~GHz have emerged as a central component of Fifth-Generation (5G) cellular standards to deliver high data rates and ultra-low latency. A key challenge in these bands is…
An unknown-position sensor can be localized if there are three or more anchors making time-of-arrival (TOA) measurements of a signal from it. However, the location errors can be very large due to the fact that some of the measurements are…
Efficient beam alignment is a crucial component in millimeter wave systems with analog beamforming, especially in fast-changing vehicular settings. This paper proposes a position-aided approach where the vehicle's position (e.g., available…
Synchronization is a fundamental procedure in cellular systems whereby an UE acquires the time and frequency information required to decode the data transmitted by a BS. Due to the necessity of using large antenna arrays to obtain the…
An indoor layout sensing and localization system in 60GHz millimeter wave (mmWave) band, named mmReality, is elaborated in this paper. The mmReality system consists of one transmitter and one mobile receiver, each with a phased array and a…
As air travel demand increases, uninterrupted high-speed internet access becomes essential. However, current satellite-based systems face latency and connectivity challenges. While prior research has focused on terrestrial 5G and…
This work investigates a multibeam system for joint sensing and communication (JSC) based on multiple-input multiple-output (MIMO) 5G new radio (NR) waveforms. In particular, we consider a base station (BS) acting as a monostatic sensor…
Millimeter-Wave (mm-Wave) frequency bands provide an opportunity for much wider channel bandwidth compared with the traditional sub-6 GHz band. Communication at mm-Waves is, however, quite challenging due to the severe propagation path…
In beyond 5G and 6G network scenarios, the use of satellites has been actively discussed for extending target monitoring areas, even for extreme circumstances, where the monitoring functionalities can be realized due to the usage of…
Visual information, captured for example by cameras, can effectively reflect the sizes and locations of the environmental scattering objects, and thereby can be used to infer communications parameters like propagation directions, receiver…
Pedestrians Localization in Non-Line-of-Sight (NLoS) regions within urban environments poses a significant challenge for autonomous driving systems. While mmWave radar has demonstrated potential for detecting objects in such scenarios, the…