相关论文: Al-Cu-Fe quasicrystals as anode of lithium ion bat…
This theoretical investigation delves into the structural, electronic, and electrochemical properties of two hexagonal iron-arsenide monolayers, 1T-FeAs and 1H-FeAs, focusing on their potential as anode materials for Lithium-ion batteries.…
As silicon is approaching its theoretical limit for the anode materials in lithium battery, searching for a higher limit is indispensable. Herein, we demonstrate the possible of achieving ultrahigh capacity over 6500 mAh g-1 in…
A Li-conversion alpha-Fe2O3@C nanocomposite anode and a high-voltage LiNi0.5Mn1.5O4 cathode are synthesized in parallel, characterized, and combined in a Li-ion battery. alpha-Fe2O3@C is prepared via annealing of maghemite iron oxide and…
A full lithium-ion-sulfur cell with a remarkable cycle life was achieved by combining an environmentally sustainable biomass-derived sulfur-carbon cathode and a pre-lithiated silicon oxide anode. X-ray diffraction, Raman spectroscopy,…
We investigate the Li2CuSb full-Heusler alloy using the first-principles electronic structure calculations and propose the electrochemical lithiation in this alloy. Band structure calculations suggest the presence of metallic nature in this…
Despite recent significant developments of Si composites, use of silicon with significance in the anodes for Li-ion batteries is still limited. In fact, nominal energy density is to be saturated around ~750 Wh/L regardless of cell-types…
In recent years, impressive advances in harvesting renewable energy have led to pressing demand for the complimentary energy storage technology. Here, a high coulombic efficiency (~ 99.7%) Al battery is developed using earth-abundant…
Metal-ion batteries are in huge demand to cope with the increasing need for renewable energy, especially in automobiles. In this work, we apply first-principle calculations to examine two-dimensional beryllium carbide (2D-Be2C) as a…
Na, K and Ca-ion battery electrode materials with appropriate electrochemical properties are desirable candidates for replacing lithium-ion batteries (LIBs) because of their natural richness and low cost. Recently, MoO2 has been reported as…
The increasing relevance of energy storage technologies demands high-capacity cathode materials for Li-ion batteries. Recently, Li-rich defect anti-fluorite Li$_5$FeO$_4$ has emerged as a high-capacity cathode material exhibiting…
Silicon is a promising anode material for next-generation lithium-ion batteries due to its exceptionally high specific capacity (3600 mAh g$^{-1}$), significantly exceeding that of conventional graphite. However, its practical application…
Graphite fluoride (CFx) cathodes coupled with lithium anodes yield one of the highest theoretical energy densities (>860 Wh/g) among primary batteries. In practice, the observed discharge voltage (~2.5 V) is significantly lower than…
The prospects of phosphorene as an anode material for high performance Li-ion battery was systematically investigated from the first principle calculations and experimental measurements. The diffusion energy barriers of a Li atom moving…
We have investigated the possibility of using aluminum functionalized silicene trilayers (ABC-Si$_4$Al$_2$) as an anode material for alkali metal ion batteries (AMIBs). First, we studied the thermodynamic stability of ABC-Si$_4$Al$_2$ using…
Quasicrystals can be considered, from the point of view of their electronic properties, as being intermediate between metals and insulators. For example, experiments show that quasicrystalline alloys such as AlCuFe or AlPdMn have…
We report the electrochemical investigation of 5% Al doped MoS$_2$@rGO composite as a high-performance anode for sodium (Na)-ion batteries. The x-ray diffraction (XRD), Raman spectroscopy and high-resolution transmission electron microscopy…
We study Na ion diffusion and electrochemical performance of NaVO$_3$ (NVO) as anode material in Li/Na--ion batteries with the specific capacity of $\approx$350 mAhg$^{-1}$ at the current density 11~mAg$^{-1}$ after 300 cycles. Remarkably,…
Cycling efficiency and rate capability of porous copper-coated, amorphous silicon thin-film negative electrodes are compared to equivalent silicon thin-film electrodes in lithium-ion batteries. The presence of a copper layer coated on the…
Starting from the Zn17Sc3 cubic approximant, new quasicrystal alloys were searched by replacement of Zn with transition elements, T. In the cases of T=Mn, Fe, Co and Ni, new icosahedral quasicrystals are formed in as-cast alloys as major…
Using first principles structure searching with density-functional theory (DFT) we identify a novel $Fm\bar{3}m$ phase of Cu$_2$P and two low-lying metastable structures, an $I\bar{4}3d$--Cu$_3$P phase, and a $Cm$--Cu$_3$P$_{11}$ phase. The…