相关论文: Femtosecond laser crystallization of amorphous tit…

Ultrashort pulsed laser annealing is an efficient technique for crystallizing amorphous semiconductors with the possibility to obtain polycrystalline films at low temperatures, below the melting point, through non-thermal processes. Here, a…

Epitaxial titanium diboride thin films have been deposited on sapphire substrates by Pulsed Laser Ablation technique. Structural properties of the films have been studied during the growth by Reflection High Energy Electron Diffraction…

This study provides a new insight into the processes which occur when thin film hydrogenated amorphous silicon is subjected to UV laser irradiation in the presence of oxygen. It achieves this by observing the effects of subjecting the films…

Femtosecond laser ablation is a process that bears both fundamental physics interest and has wide industrial applications. For decades, the lack of probes on the relevant time and length scales has prevented access to the highly…

We report an experimental investigation on the irradiation of copper thin films with high repetition rate femtosecond laser pulses (1040 nm, 50 MHz), in ambient air and liquid water. We observe a novel, striking phenomenon of chromatic…

Crystallization of thin film materials by exploiting laser induced crystallization has been advancing for the past four decades. This unique thin film technique has been predominantly used in processing thin film materials made of a single…

Thin TiO2 films on quartz substrates were prepared by spin coating of undoped and metal-ion-doped Sol Gel precursors. These films were characterised by Scanning Electron Microscopy, Laser Raman Microspectroscopy, Xray Diffraction and UV Vis…

The ability to control porosity in oxide thin films is one of the key factors that determine their properties. Despite the abundance of dry processes for the synthesis of oxide porous layers, the high porosity range is typically achieved by…

Thin coatings of Chromium oxide have been used for applications as absorbing material in solar cells, as protections for magnetic data recording devices and as shields in flexible solar cells. Thin coatings of pure chromium were vacuum…

Thin films of thulium and ytterbium-doped titanium oxide were grown by metal-organic spray pyrolysis deposition from titanium(IV)oxide bis(acetylacetonate), thulium(III) tris(2,2,6,6-tetramethyl-3,5-heptanedionate) and ytterbium(III)…

The specific mechanisms which leads to the formation of fractal nanostructures by pulsed laser deposition remain elusive despite intense research efforts, motivated mainly by the technological interest in obtaining tailored nanostructures…

Sub-picosecond optical laser processing of metals is actively utilized for modification of a heated surface layer. But for deeper modification of different materials a laser in the hard x-ray range is required. Here, we demonstrate that a…

We investigated laser-induced periodic surface structures (LIPSS) generated on indium-tin-oxide (ITO) thin films with femtosecond laser pulses in the infrared region. Using pulses between 1.6 and 2.4 ${\mu}$m central wavelength, we observed…

Thin aluminum oxide films were deposited by a new and simple physicochemical method called chemical liquid phase deposition (CLD) on semiconductor materials. Aluminum sulfate with crystallized water and sodium bicarbonate were used as…

In this work, we investigate the correlation between morphology, composition, and the mechanical properties of metallic amorphous tungsten-oxygen and amorphous tungsten-oxide films deposited by Pulsed Laser Deposition. This correlation is…

The catalytic activity of nanotubular titanium dioxide films formed during the oxidation of acetone to carbon dioxide under the action of visible light with a wavelength of 450 nm was found to be approximately 2 times higher compared to…

The advent of ultrahigh-power femtosecond lasers creates a need for optical components suitable to handle ultrahigh light intensities. Due to the unavoidable laser-induced ionization of matter, these components will have to be based on a…

In this work, for the first time of our knowledge, we present a well-supported procedure to fabricate ridge optical waveguides onto thin films of PLZT by femtosecond laser ablation. In order to achieve smooth guiding structures to guarantee…

We present a study on the crystallization process of undoped and Ta doped TiO2 amorphous thin films. In particular, the effect of ultra-fast annealing treatments in environments characterized by different oxygen concentrations is…

Thin Cr films 28-nm thick deposited on glass substrates were processed by scanning low-intensity femtosecond laser pulses with energy well below single-pulse damage threshold. Two types of laser-induced periodic surface structures (LIPSS)…