相关论文: A Hybrid Dynamic-regenerative Damping Scheme for E…
Energy efficiency is a crucial issue towards longterm deployment of compliant robots in the real world. In the context of variable impedance actuators (VIAs), one of the main focuses has been on improving energy efficiency through reduction…
This study is part of research aiming at increasing the range of dynamic tasks for teleoperated field robotics in order to allow operators to use the full range of human motions without being limited by the dynamics of the robotic…
Compliant robotics have seen successful applications in energy efficient locomotion and cyclic manipulation. However, exploitation of variable physical impedance for energy efficient sequential movements has not been extensively addressed.…
In this paper we demonstrate a novel alternating direction method of multipliers (ADMM) algorithm for the solution of the hybrid vehicle energy management problem considering both power split and engine on/off decisions. The solution of a…
This paper proposes a novel wide-area control strategy for modulating the active power injections to damp the critical frequency oscillations in power systems, this includes the inter-area oscillations and the transient frequency swing. The…
Integrating power electronics with batteries can offer many advantages, including load sharing and balancing with parallel connectivity. However, parallel batteries with differing voltages and power profiles can cause large circulating…
This paper represents a novel regenerative braking approach for the Electric Vehicles. The proposed method solves the short-range problem which is corresponding to the charge of the battery pack. The DTC switching algorithm has been…
Power systems dominated by converter-interfaced distributed energy resources (DERs) typically exhibit weaker damping capabilities and lower inertia, compromising system stability. Although individual DER controllers are evolving to provide…
We prove that aerodynamic co-contraction in a redundant dual-rotor actuator can tune a passive, trim-defined aero-mechanical damping while keeping the commanded net force constant. In particular, we define an incremental damping coefficient…
A novel variable dc-link voltage technique is proposed to reduce the traction losses for electrical drive applications. A 100-unit cascaded multilevel converter is developed to generate the variable dc-link voltage. Experimental measurement…
Wearable robots are limited by their actuators performances because they must bear the weight of their own power system and energy source. This paper explores the idea of leveraging hybrid modes to meet multiple operating points with a…
In the paper, a vibration damping system powered by harvested energy with implementation of the so-called SSDV (synchronized switch damping on voltage source) technique is designed and investigated. In the semi-passive approach, the…
Power electronic devices such as HVDC and FACTS can be used to improve the damping of poorly damped inter-area modes in large power systems. This involves the use of wide-area feedback signals, which are transmitted via communication…
Power distribution grids with high PV generation are exposed to voltage disturbances due to the unpredictable nature of renewable resources. Smart PV inverters, if controlled in coordination with each other and continuously adapted to the…
Dynamic voltage scaling (DVS) is one of the most effective techniques for reducing energy consumption in embedded and real-time systems. However, traditional DVS algorithms have inherent limitations on their capability in energy saving…
Increased penetration of inverter-connected renewable energy sources (RES) in the power system has resulted in a decrease in available rotational inertia which serves as an immediate response to frequency deviation due to disturbances. The…
A widely embraced approach to mitigate the dynamic degradation in low-inertia power systems is to mimic generation response using grid-connected inverters to restore the grid's stiffness. In this paper, we seek to challenge this approach…
The growing integration of distributed energy resources into distribution systems poses challenges for voltage regulation. Dynamic VAR Compensators (DVCs) are a new generation of power electronics-based Volt/VAR compensation devices…
We present hardware/software techniques to intelligently regulate supply voltage and clock frequency of intermittently-computing devices. These devices rely on ambient energy harvesting to power their operation and small capacitors as…
The aim of this work is two-fold: to design devices for passive electric damping of structural vibrations by distributed piezoelectric transducers and electric networks, and to experimentally validate the effectiveness of such a damping…