相关论文: Influence of particle size and agglomeration in so…
In this paper, we present the results of single-track experiments conducted for different fractions of standard AlSi10Mg powder, which were sieved to achieve varying mean size of the particles. We observed strong differences in the melting…
High-temperature solid oxide electrolysis cells (SOECs) are a potential core power-to-X (P2X) technology due to their unparalleled system efficiencies, that can exceed 85 % when excess heat from exothermic downstream processes is available.…
Anionic surfactants based on fatty acids are usually used to modify the particle surface properties of CaCO$_3$ with the aim to enhance its dispersion and compatibility with polymer matrices. In this study sodium oleate was used for the…
In nanoparticulate phase-separating electrodes, phase separation inside the particles can be hindered during their charge/discharge cycles even when a thermodynamic driving force for phase separation exists. In such cases, particles may…
The unique structural features and suitability of the SiO2 micro particles in different application areas have mobilized a worldwide interest in the last few decades. In this report a classical method known as the Stober method has been…
In this study, we present a well-defined methodology for conducting Operando X-ray absorption near-edge structure spectroscopy (XANES) in conjunction with transmission X-ray nano computed tomography (TXM-nanoCT) experiments on the…
Iron oxide nano particles with nominal Fe2O3 stoichiometry were synthesized by a wet, soft chemical method with the heat treatment temperatures from 250{\deg}C to 900{\deg}C in air. The variation in the structural properties of the nano…
Despite ongoing efforts aimed at increasing energy density in all-solid-state-batteries, the optimal composite cathode morphology, which requires minimal volume change, small void development, and good interfacial contact, remains a…
Correlating the microstructure of an energy conversion device to its performance is often a complex exercise, notably in solid oxide fuel cell (SOFC) research. SOFCs combine multiple materials and interfaces that evolve in time due to high…
Simultaneous study of magnetic and electrocatalytic properties of cobaltites under extreme conditions expands understanding of physical and chemical processes proceeding in them with the possibility of their further practical application.…
Wide proliferation of low temperature hydrogen fuel cell systems, a key part of the hydrogen economy, is hindered by degradation of the platinum cathode catalyst. Here, we provide a device level assessment of the molecular scale catalyst…
Anisotropic, submicrometer sized particles are versatile systems providing interesting features in creating ordering in 2-dimensional systems. Combining hard ellipsoids with a soft shell further enhances the opportunities to trigger and…
Aggregation of nanoparticles of given size $R$ induced by addition of a polymer strongly depends on its degree of rigidity. This is shown here on a large variety of silica nanoparticle self-assemblies obtained by electrostatic complexation…
Cu-based electrocatalysts exhibits enormous potential for electrochemical CO2 conversion to added-value products. However, high selectivity, specially towards C2+ products, remains a critical challenge for its implementation in commercial…
The strikingly different charge transport behaviors in nanocomposites of multiwall carbon nanotubes (MWNTs) and conducting polymer polyethylene dioxythiophene - polystyrene sulfonic acid (PEDOT-PSS) at low temperatures are explained by…
The large volume change of the silicon (Si) during lithiation and delithiation process has long been a problem impeding its application as one of the most promising anode materials for LIBs. In this paper, we proposed a conceptually new…
This paper presents synthesis methods and multifunctional properties of porous Co3O4 nanoplatelets and nanowires. Surprisingly, significantly superior Li-ion battery performance compared to other cathode materials is exhibited in the same…
This study examined the effects of surfactants on the motion and positioning of microparticles in an inhomogeneous electric field. The microparticles were suspended in oil with a surfactant and the electric field was generated using…
Modified structures of SAPO-34 were prepared using polyethylene glycol as the mesopores generating agent. The synthesized catalysts were applied in methanol-to-olefins (MTO) process. All modified synthesized catalysts were characterized via…
The reduction and control of particulate matter generated by fossil fuel combustion are among the main issues for actual and future combustion devices due to the increasingly stringent emission regulations. Recently, various fuels have been…