相关论文: A 3.8 ps RMS time synchronization implemented in a…

Phase clocks are synchronization tools that implement a form of logical time in distributed systems. For systems tolerating transient faults by self-repair of damaged data, phase clocks can enable reasoning about the progress of distributed…

The deployment of neural networks on heterogeneous SoCs coupled with custom accelerators is a challenging task because of the lack of end-to-end software tools provided for these systems. Moreover, the already available low level schedules…

Detector readout systems for medium to large scale physics experiments, and instruments in some other fields as well, are generally composed of multiple front-end digitizer boards distributed over a certain area. Often, this hardware has to…

The increasing number of qubits in quantum processors necessitates a corresponding increase in the number of control lines between the processor, which is typically operated at cryogenic temperatures, and external electronics. Scaling poses…

A new Digital Pulse Processing (DPP) system, based on domino ring sampler version 4 (DRS4), with good time resolution for the LaBr3 detectors has been developed and different digital timing analysis methods for processing the detector raw…

Phase, time, and frequency coordination are crucial for the coherent operation of distributed antenna arrays. This paper demonstrates a high accuracy decentralized time synchronization method for arrays with dynamic connectivity. To…

Large intelligent surface (LIS) has gained momentum as a potential 6G-enabling technology that expands the benefits of massive multiple-input multiple-output (MIMO). On the other hand, orthogonal space-division multiplexing (OSDM) may give…

This paper presents a new procedure for phase detector measurements that allows the use of generators that share a 10 MHz reference oscillator but do not synchronize in phase, in other words, quasi-synchronized RF generators. The objectives…

We present a versatile rf pulse control system that has been designed for multi-qubit quantum experiments. One instrument can be scaled to provide 32 channels of rf between 10 - 450 MHz. Synchronization can be achieved across multiple…

A new generation of radio telescopes is achieving unprecedented levels of sensitivity and resolution, as well as increased agility and field-of-view, by employing high-performance digital signal processing hardware to phase and correlate…

Objective- Heart rate monitoring using wrist type Photoplethysmographic (PPG) signals is getting popularity because of construction simplicity and low cost of wearable devices. The task becomes very difficult due to the presence of various…

The ZEUS Central Tracking Detector utilizes a time difference measurement to provide a fast determination of the z-coordinate of each hit. The z-by-timing measurement is achieved by using a Time-to-Amplitude Converter which has an intrinsic…

Phase shifting interferometric (PSI) techniques are among the most sensitive phase measurement methods. Owing to its high sensitivity, any minute phase change caused due to environmental instability results into, inaccurate phase…

This paper describes the data acquisition and trigger system of the Thin Time-of-flight PET (TT-PET) scanner. The system is designed to read out in the order of 1000 pixel sensors used in the scanner and to provide a reference timing signal…

The recent introduction of coherent optical communications has created a compelling need for ultra-fast phase-sensitive measurement techniques operating at milliwatt peak power levels and in time scales ranging from sub-picoseconds to…

The multi-pumping resource sharing technique can overcome the limitations commonly found in single-clocked FPGA designs by allowing hardware components to operate at a higher clock frequency than the surrounding system. However, this…

The design and performance of a multi-G-sample/s fully-synchronous analog transient waveform recorder I.C. ("SST") with fast and flexible trigger capabilities is presented. Containing 4 channels of 256 samples per channel and fabricated in…

Electronic devices primarily aim to offer low power consumption, high speed, and a compact area. The performance of very large-scale integration (VLSI) devices is influenced by arithmetic operations, where multiplication is a crucial…

Recently, a new precoding technique called orthogonal time-frequency signaling (OTFS) has been proposed for time- and frequency-selective communication channels. OTFS precodes a data frame with a complete set of spreading sequences and…

The performance of any elliptic curve cryptography hardware accelerator significantly relies on the efficiency of the underlying point multiplication (PM) architecture. This article presents a hardware implementation of field-programmable…