相关论文: Characterising Transient Noise in the LIGO Detecto…
The data taken by the advanced LIGO and Virgo gravitational-wave detectors contains short duration noise transients that limit the significance of astrophysical detections and reduce the duty cycle of the instruments. As the advanced…
On September 14, 2015, a gravitational wave signal from a coalescing black hole binary system was observed by the Advanced LIGO detectors. This paper describes the transient noise backgrounds used to determine the significance of the event…
The sensitivity of the Advanced LIGO detectors to gravitational waves can be affected by environmental disturbances external to the detectors themselves. Since the transition from the former initial LIGO phase, many improvements have been…
Glitches are non-Gaussian noise transients originating from environmental and instrumental sources that contaminate data from gravitational wave detectors. Some glitches can even mimic gravitational wave signals from compact object mergers,…
Quality improvement of interferometric data collected by gravitational-wave detectors such as Advanced LIGO and Virgo is mission critical for the success of gravitational-wave astrophysics. Gravitational-wave detectors are sensitive to a…
There is a broad class of astrophysical sources that produce detectable, transient, gravitational waves. Some searches for transient gravitational waves are tailored to known features of these sources. Other searches make few assumptions…
Noise of non-astrophysical origin will contaminate science data taken by the Advanced Laser Interferometer Gravitational-wave Observatory (aLIGO) and Advanced Virgo gravitational-wave detectors. Prompt characterization of instrumental and…
Between 2007 and 2010 Virgo collected data in coincidence with the LIGO and GEO gravitational-wave (GW) detectors. These data have been searched for GWs emitted by cataclysmic phenomena in the universe, by non-axisymmetric rotating neutron…
In the coming years gravitational-wave detectors will undergo a series of improvements, with an increase in their detection rate by about an order of magnitude. Routine detections of gravitational-wave signals promote novel astrophysical…
Data quality assessment plays an essential role in the quest to detect gravitational wave signals in data from the LIGO and Virgo interferometric gravitational wave detectors. Interferometer data contains a high rate of noise transients…
The observation of gravitational waves is hindered by the presence of transient noise (glitches). We study data from the third observing run of the Advanced LIGO detectors, and identify new glitch classes. Using training sets assembled by…
The LIGO Scientific Collaboration and the Virgo Collaboration have cataloged eleven confidently detected gravitational-wave events during the first two observing runs of the advanced detector era. All eleven events were consistent with…
Data from ground-based gravitational-wave detectors like LIGO contain many types of noise. Glitches are short bursts of non-Gaussian noise that may hinder our ability to identify or analyse gravitational-wave signals. They may have…
An important goal for LIGO (the Laser Interferometer Gravitational-Wave Observatory) and Virgo is to find periodic sources of gravitational waves. The LIGO and Virgo detectors are sensitive to a variety of noise of non-astrophysical origin,…
Gravitational-wave detectors are sensitive not only to astrophysical gravitational waves, but also to the fluctuating Newtonian gravitational forces of moving masses in the ground and air around the detector. This paper studies the…
In 2009-2010, the Laser Interferometer Gravitational-wave Observa- tory (LIGO) operated together with international partners Virgo and GEO600 as a network to search for gravitational waves of astrophysical origin. The sensitiv- ity of these…
Transient noise appearing in the data from gravitational-wave detectors frequently causes problems, such as instability of the detectors and overlapping or mimicking gravitational-wave signals. Because transient noise is considered to be…
It is expected that interferometric gravitational wave detectors such as LIGO \cite{Barish99} will be eventually limited by fundamental noise sources like shot noise and Brownian motion, as well as by seismic noise. In the commissioning…
We present a new ${\it{gating}}$ method to remove non-Gaussian noise transients in gravitational wave data. The method does not rely on any a-priori knowledge on the amplitude or duration of the transient events. In light of the character…
The LIGO observatories detect gravitational waves through monitoring changes in the detectors' length down to below $10^{-19}$\,$m/\sqrt{Hz}$ variation---a small fraction of the size of the atoms that make up the detector. To achieve this…