相关论文: Fracture toughness characterization through notche…
Ductile damage modeling within the Small Punch Test (SPT) is extensively investigated. The capabilities of the SPT to reliably estimate fracture and damage properties are thoroughly discussed and emphasis is placed on the use of notched…
In recent years, the pre-notched or pre-cracked small punch test (P-SPT) has been successfully used to estimate the fracture properties of metallic materials for cases in which there is not sufficient material to identify these properties…
In this review article we consider the crack growth resistance ofmicrometer and submicrometer sized samples from the fracture mechanics point of view. Standard fracture mechanics test procedures were developed for macroscale samples, and…
This paper describes an attempt to construct a first-principles theory of the fracture toughness of crystalline solids. It is based on the thermodynamic dislocation theory (TDT), which starts with the assertion that dislocations in solids…
Guided by recent advances in the understanding of nucleation and propagation of fracture in elastic brittle materials, this paper proposes a suite of three simple experiments that permit the measurement of the three macroscopic material…
In this paper the problem of a plane strain hydraulic fracture in elasto-plastic material is analyzed. The analysis is based on Finite Element Method computations of crack propagation and closure to simulate the Mini-Frac calibration test.…
We propose a full 3D benchmark problem for brittle fracture based on experiments as well as a validation in the context of phase-field models. The example consists of a series of four-point bending tests on graphite specimens with sharp…
Fracture toughness is the material property characterizing resistance to failure. Predicting its value from the solid structure at the atomistic scale remains elusive, even in the simplest situations of brittle fracture. We report here…
Fractured metal fragments with rough and irregular surfaces are often found at crime scenes. Current forensic practice visually inspects the complex jagged trajectory of fractured surfaces to recognize a ``match'' using comparative…
Stress-strain plots based on nanoindentation load-depth curves reflected cracking phenomenon. A transition from ductile to brittle fracture was observed on increasing the depth or load of indenter penetration. A new approach with shape…
Soft polymers are ubiquitous materials in nature and as engineering materials with properties varying from rate-independent to rate-dependent. Current fracture toughness measures are non-unique for rate-dependent soft materials for varying…
In recent years, there has been discussion in the literature regarding methods of estimating the magnitude of the minimum principal stress from subsurface fracture injection tests, commonly called Diagnostic Fracture Injection Tests…
Analytical models have been developed for fracture propagation over the last several decades and are now considered with renewed interest; the range of their applicability varies for different materials and different loading conditions.…
We develop a novel constitutive modeling approach for the analysis of fracture propagation in quasi-brittle materials using the Material Point Method. The kinematics of constitutive models is enriched with an additional mode of localized…
The onset of sub-critical crack growth during slow strain rate tensile testing (SSRT) is assessed through a combined experimental and modeling approach. A systematic comparison of the extent of intergranular fracture and expected hydrogen…
Fracture growth in a material is strongly influenced by the presence of inhomogeneities, which deviate crack trajectories from rectilinearity and deeply affect failure. Increasing crack tortuosity is connected to enhancement of fracture…
The accumulated entropy is used to evaluate the initiation of crack in flat notched specimen made of stainless steel 304. Two notch radii have been studied to capture the thermography of crack initiation and measure accumulated heat…
The accurate measurement of fracture resistance in elastomers is essential for predicting the mechanical limits of soft devices. Usually, this is achieved by performing tearing or peeling experiments on thin-sheet samples. Here, we show…
Notched components are commonly used in engineering structures, where stress concentration may easily lead to crack initiation and development. The main goal of this work is to develop a simple numerical method to predict the structural…
In this work, the finite elements method (FEM) is used to analyse the growth of fretting cracks. FEM can be favourably used to extract the stress intensity factors in mixed mode, a typical situation for cracks growing in the vicinity of a…