相关论文: Constitutive relations for shear fronts in shear-t…
A scaling analysis is undertaken for the load balance in sliding friction in the hydrodynamic lubrication regime, with a particular emphasis on power-law shear-thinning typical of a structured liquid. It is argued that the shear-thinning…
We experimentally characterize the impact response of concentrated suspensions consisting of cornstarch and water. We observe that the suspensions support a large normal stress -- on the order of MPa -- with a delay after the impactor hits…
We document a sequence of bifurcations and elastic patterns in sheared bent sheets of intermediate aspect ratio. The sheets undergo inversion of curvature through the passage of localized features, often in S-shaped pairs. Nested…
Colloidal shear thickening presents a significant challenge because the macroscopic rheology becomes increasingly controlled by the microscopic details of short ranged particle interactions in the shear thickening regime. Our measurements…
We compute the rheological properties of inelastic hard spheres in steady shear flow for general shear rates and densities. Starting from the microscopic dynamics we generalise the Integration Through Transients (\textsc{itt}) formalism to…
We do extensive simulations of a simple model of shear-driven jamming in two dimensions to analyze the velocity distribution at different densities $\phi$ around the jamming density $\phi_J$ and at different low shear strain rates,…
The mechanical performance of reinforced composites is strongly influenced at different scales by the stress transferred at the matrix-fibre interfaces and at any surface where material discontinuity occurs. In particular, the mechanical…
We propose a constitutive model to predict the viscosity of fiber suspensions, which undergoes shear thinning, at various volume fractions, aspect ratios, and shear stresses/rates. We calibrate the model using the data from direct numerical…
A stress-affected chemical reaction front propagation is considered utilizing the concept of a chemical affinity tensor. A reaction between an elastic solid and diffusing constituents, localized at the reaction front, is considered. As a…
We study the effect of pre-collisional velocity correlations on granular shear flow by molecular dynamics simulations of the inelastic hard sphere system. Comparison of the simulations with the kinetic theory reveals that the theory…
The transient response of model hard sphere glasses is examined during the application of steady rate start-up shear using Brownian Dynamics (BD) simulations, experimental rheology and confocal microscopy. With increasing strain the glass…
We discuss crack propagation along the interface between two dissimilar materials. The crack edge separates two states of the interface, ``stick'' and ``slip''. In the slip region we assume that the shear stress is proportional to the…
A general phenomenological reaction-diffusion model for flow-induced phase transitions in complex fluids is presented. The model consists of an equation of motion for a nonconserved composition variable, coupled to a Newtonian stress…
Recent advances in shear-thickening suspension rheology suggest a relation between (wet) suspension flow below jamming and (dry) granular physics. To probe this connection, we simulated the contact force networks in suspensions of…
Rate-effects in sheared disordered solids are studied using molecular dynamics simulations of binary Lennard-Jones glasses in two and three dimensions. In the quasistatic (QS) regime, systems exhibit critical behavior: the magnitudes of…
In this work we explore the rheology of very concentrated (0.55<$\Phi$<0.67) suspensions of carbonyl iron (CI) particles coated by a small polymer. A strong DST is observed in a large range of volume fraction presenting some specificities…
Impacted with sufficiently large stress, a dense, initially liquid-like suspension can be forced into a solid-like state through the process of shear jamming. While the onset of shear jamming has been investigated extensively, less is known…
We study the effect of the sample thickness in planar crack front propagation in a disordered elastic medium using the random fuse model. We employ different loading conditions and we test their stability with respect to crack growth. We…
We use 2D numerical simulations to study dense suspensions of non-Brownian hard particles using the Critical Load Model (CLM) under constant confining pressures. This simple model shows discontinuous shear thickening (DST) as the tangential…
We consider the dynamics and kinetic roughening of wetting fronts in the case of forced wetting driven by a constant mass flux into a 2D disordered medium. We employ a coarse-grained phase field model with local conservation of density,…