相关论文: Structural ordering of laser-processed FePdCu thin…
Fe-based metallic glasses are promising functional materials for advanced magnetism and sensor fields. Tailoring magnetic performance in amorphous materials requires a thorough knowledge of the correlation between structural disorder and…
Utilizing continues-wave or pulsed laser to induce nano-structures on various material surfaces is one significant method in nano-fabrication technology. In this report, we investigate the formation of high spatial frequency periodic…
The preparation in thin film form of the known icosahedral phase in Ti-Ni-Zr bulk alloys has been investigated as a function of substrate temperature. Films were deposited by Pulsed Laser Deposition on sapphire substrates at temperatures…
We report an experimental and computational study of magnetic and electronic properties of the layered Ru(V) oxide SrRu2O6 (hexagonal, P-3 1m), which shows antiferromagnetic order with a N\'eel temperature of 563(2) K, among the highest for…
Iron oxide nano particles with nominal Fe2O3 stoichiometry were synthesized by a wet, soft chemical method with the heat treatment temperatures from 250{\deg}C to 900{\deg}C in air. The variation in the structural properties of the nano…
We show that the low-temperature physics of molecular nanomagnets, contrary to the prevailing one-molecule picture, must be determined by the long-range magnetic ordering due to many-body dipolar interactions. The calculations here…
We report on Boron diffusion and subsequent crystallization of Co$_{40}$Fe$_{40}$B$_{20}$ (CoFeB) thin films on SiO$_2$/Si(001) substrate using pulsed laser deposition. Secondary ion mass spectroscopy reveals Boron diffusion at the…
The formation and properties of laser-induced periodic surface structures (LIPSS) were investigated on carbon fibers under irradiation of fs-laser pulses characterized by a pulse duration $\tau$ = 300 fs and a laser wavelength $\lambda$ =…
Synchrotron X-ray diffraction patterns were measured and analyzed for a polycrystalline sample of the room-temperature ferromagnet Sr3.12Er0.88Co4O10.5 from 300 to 650 K, from which two structural phase transitions were found to occur…
Investigation of crystallization in an 5BDSR amorphous alloy by system Fe-Cu-Nb-Si-B under the influence of an incoherent optical radiation generated by gas discharge flash-lamp using X-ray diffraction scattering. It is shown that depending…
We investigated the crystal structure, magnetic behavior, and optical properties of the layered honeycomb compound Na2Cu2TeO6. X-ray and neutron diffraction confirmed a monoclinic structure, with Cu ions arranged in dimerized chains.…
Nanoparticles of rubidium cobalt hexacyanoferrate (Rb$_j$Co$_k$[Fe(CN)$_6$]$_l \cdot n$H$_2$O) were synthesized using different concentrations of the polyvinylpyrrolidone (PVP) to produce four different batches of particles with…
PbZr0.52Ti0.48O3/La0.67Sr0.33MnO3(PZT/LSMO) bilayer with surface roughness ~ 1.8 nm thin films have been grown by pulsed laser deposition on LaAlO3(LAO) substrates. High remnant polarization (30-54 micro C/cm2), dielectric…
Bulk Au-Fe alloys separate into Au-based fcc and Fe-based bcc phases, but L1$_0$ and L1$_2$ orderings were reported in single-phase Au-Fe nanoparticles. Motivated by these observations, we study the structural and ordering energetics in…
High quality MgB2 thin films have been obtained by pulsed laser deposition both on MgO and on Al2O3 substrates using different methods. In the standard two-step procedure, an amorphous precursor layer is deposited at room temperature…
Polycrystalline samples of the layered iron arsenides Sr2CrO3FeAs and Ba2ScO3FeAs were synthesized by high temperature solid state reactions and their crystal structures determined by the X-ray powder diffraction. Their structures are…
The evolution of the nuclear and magnetic structures of TlFe$_{1.6}$Se$_2$ was determined in the temperature range of 5-450\,K using single crystal neutron diffraction. The Fe layers in these materials develop a corrugation in the…
Nanocrystalline metals are promising radiation tolerant materials due to their large interfacial volume fraction, but irradiation-induced grain growth can eventually degrade any improvement in radiation tolerance. Therefore, methods to…
Multiferroic BiFeO3 epitaxial films with thickness ranging from 40 nm to 960 nm were grown by pulsed laser deposition on SrTiO3 (001) substrates with SrRuO3 bottom electrodes. X-ray characterization shows that the structure evolves from…
Au-Cu bimetallic nanoparticles (NPs) grown on TiO 2 (110) have been followed in-situ using grazing incidence x-ray diffraction and x-ray photoemission spectroscopy from their synthesis to their exposure to a CO/O 2 mixture at low pressure…