相关论文: An Efficient Reconfigurable FIR Digital Filter Usi…

Computational Fluid Dynamics (CFD) simulations are often constrained by the memory-bound nature of sparse matrix-vector operations, which eventually limits performance on modern high-performance computing (HPC) systems. This work introduces…

This letter considers the design of linear-phase finite-length impulse response (FIR) filters for equalization of the frequency responses of digital-to-analog converters (DACs). The letter derives estimates for the filter orders required,…

In this paper we represent a new framework for integrated distributed and reliable systems. In the proposed framework we have used three parts to increase Satisfaction and Performance of this framework. At first we analyze previous…

In this letter, we incorporate index modulation (IM) into affine frequency division multiplexing (AFDM), called AFDM-IM, to enhance the bit error rate (BER) and energy efficiency (EE) performance. In this scheme, the information bits are…

In this paper, we investigate the performance of multiple-input multiple-output (MIMO) fading channels assisted by a reconfigurable intelligent surface (RIS), through the employment of partition-based RIS schemes. The proposed schemes are…

In modern computing units, division operations are generally slower than other arithmetic operations and require more resources, such as area and power, than multiplication. To reduce the delay, fast division algorithms use an initial…

This paper addresses the numerical optimization of proportional-integral-derivative (PID) controllers for linear time-invariant systems with delays, where the derivative action is implemented using a low-pass filter. While performance…

In this work we propose an adaptive linear receiver structure based on interpolated finite impulse response (FIR) filters with adaptive interpolators for direct sequence code division multiple access (DS-CDMA) systems in multipath channels.…

In this paper, the design of a computationally efficient variable bandpass digital filter is presented. The center frequency and bandwidth of this filter can be changed online without updating the filter coefficients. The warped filters,…

We present a novel energy-based numerical analysis of semilinear diffusion-reaction boundary value problems. Based on a suitable variational setting, the proposed computational scheme can be seen as an energy minimisation approach. More…

In a recent paper, I. Selesnick and C.S. Burrus developed a design method for maximally flat FIR low-pass digital filters with reduced group delay. Their approach leads to a system of polynomial equations depending on three integer design…

Processing-in-memory (PIM) seeks to eliminate computation/memory data transfer using devices that support both storage and logic. Stateful logic techniques such as IMPLY, MAGIC and FELIX can perform logic gates within memristive crossbar…

This work is to develop a general framework, namely analytical iterative reconstruction (AIR) method, to incorporate analytical reconstruction (AR) method into iterative reconstruction (IR) method, for enhanced CT image quality and…

The conventional solutions for fault-detection, identification, and reconstruction (FDIR) require centralized decision-making mechanisms which are typically combinatorial in their nature, necessitating the design of an efficient distributed…

Energy disaggregation, known in the literature as Non-Intrusive Load Monitoring (NILM), is the task of inferring the energy consumption of each appliance given the aggregate signal recorded by a single smart meter. In this paper, we propose…

In the "Big Data" era, a lot of data must be processed and moved between processing and memory units. New technologies and architectures have emerged to improve system performance and overcome the memory bottleneck. The memristor is a…

The problem of optimizing discrete phases in a reconfigurable intelligent surface (RIS) to maximize the received power at a user equipment is addressed. Comments on [1] are provided. Updated necessary and sufficient conditions for its Lemma…

We numerically demonstrate that joint optimization of FIR based pulse-shaper and receiver filter results in an improved system performance, and shorter filter lengths (lower complexity), for 4-PAM 100 GBd IM/DD systems.

In simulation sciences, it is desirable to capture the real-world problem features as accurately as possible. Methods popular for scientific simulations such as the finite element method (FEM) and finite volume method (FVM) use piecewise…

This paper presents a novel algorithm for the modulus operation for FPGA implementation. The proposed algorithm use only addition, subtraction, logical, and bit shift operations, avoiding the complexities and hardware costs associated with…