相关论文: Coexistence Analysis between Radar and Cellular Sy…

This paper considers multiple-input multiple-output (MIMO) relay communication in multi-cellular (interference) systems in which MIMO source-destination pairs communicate simultaneously. It is assumed that due to severe attenuation and/or…

We propose the joint dynamic power allocation and multi-relay selection for the cohabitation of high-priority military radar and low-priority commercial 5G communication. To improve the 5G network performance, we design the full-duplex…

We consider a multi-cell Massive MIMO system in a line-of-sight (LoS) propagation environment, for which each user is served by one base station, with no cooperation among the base stations. Each base station knows the channel between its…

Millimeter-wave (mmWave) massive multi-user multiple-input multiple-output (MU-MIMO) technology promises unprecedentedly high data rates for next-generation wireless systems. To be practically viable, mmWave massive MU-MIMO basestations…

Aerial-ground interference mitigation has been deemed as the main challenge in realizing cellular-connected unmanned aerial vehicle (UAV) communications. Due to the line-of-sight (LoS)-dominant air-ground channels, the UAV generates/suffers…

Radio localization is applied in high-frequency (e.g., mmWave and THz) systems to support communication and to provide location-based services without extra infrastructure. {For solving localization problems, a simplified, stationary,…

In the millimeter waves (mmWave) bands considered for 5G and beyond, the use of very high frequencies results in the interruption of communication whenever there is no line of sight between the transmitter and the receiver. Blockages have…

The two-stage precoding has been proposed to reduce the overhead of both the channel training and the channel state information (CSI) feedback for the massive multiple-input multiple-output (MIMO) system. But the overlap of the…

When small cells are densely deployed in the fifth generation (5G) cellular networks, switching off a part of base stations (BSs) is a practical approach for saving energy consumption considering the variation of traffic load. The small…

The use of large arrays might be the solution to the capacity problems in wireless communications. The signal-to-noise ratio (SNR) grows linearly with the number of array elements $N$ when using Massive MIMO receivers and half-duplex…

We investigate a spectrum-sharing system with non-severely faded mutual interference links, where both the secondary-to-primary and primary-to-secondary channels have a Line-of-Sight (LoS) component. Based on a Rician model for the LoS…

The integration of reconfigurable intelligent surfaces (RIS) with extremely large multiple-input multiple-output (MIMO) arrays at the base station has emerged as a key enabler for enhancing wireless network performance. However, this setup…

Increased amounts of bandwidth are required to guarantee both high-quality/high-rate wireless services (4G and 5G) and reliable sensing capabilities such as automotive radar, air traffic control, earth geophysical monitoring and security…

This paper investigates a coordinated multi-cell integrated sensing, communication, and powering (ISCAP) system operating in the electromagnetic near field, where each base station (BS) employs an extremely large-scale antenna array (ELAA)…

This paper proposes an energy-efficient scheme for multicell multiple-input, multiple-output (MIMO) simultaneous transmit and reflect (STAR) reconfigurable intelligent surfaces (RIS)-assisted broadcast channels by employing rate splitting…

The coming extension of cellular technology to base-stations in low-earth orbit (LEO) requires a fresh look at terrestrial 3GPP channel models. Relative to such models, sky-to-ground cellular channels will exhibit less diffraction, deeper…

In this paper, we study the achievable rate region of 1-layer rate splitting (RS) in the presence of hardware impairment (HWI) and improper Gaussian signaling (IGS) for a single-cell reconfigurable intelligent surface (RIS) assisted…

Joint communication and sensing (JCAS) networks are envisioned as a key enabler for a variety of applications which demand reliable wireless connectivity along with accurate and robust sensing capability. When sensing and communication…

Multifunction phased array radars (MPARs) exploit the intrinsic flexibility of their active electronically steered array (ESA) to perform, at the same time, a multitude of operations, such as search, tracking, fire control, classification,…

Due to their ability to create favorable line-of-sight (LoS) propagation environments, intelligent reflecting surfaces (IRSs) are regarded as promising enablers for future millimeter-wave (mm-wave) wireless communication. In this paper, we…