相关论文: Impact of micro-alloying on the plasticity of Pd-b…
Materials with a negative Poisson's ratio, also known as auxetic materials, exhibit unusual and counterintuitive mechanical behavior - becoming fatter in cross-section when stretched. Such behavior is mostly attributed to some special…
Small-scale plasticity and creep behavior of a Zr-based BMG were investigated using nanoindentation. Four load functions, differing only in hold times of 0, 10, 30, and 60 seconds at peak load, were applied. Results indicate spatially…
The impact of severe plastic deformation by high-pressure torsion on the relaxation of the glassy and supercooled liquid states of Pd$_{40}$Ni$_{40}$P$_{20}$ was investigated using a combination of differential scanning calorimetry,…
Experimental data on the compressive strength $\sigma_{\rm max}$ versus strain rate ${\dot \varepsilon}_{\rm eng}$ for metallic glasses undergoing uniaxial compression shows significantly different behavior for different alloys. For some…
Sheared multi-component bulk metallic glasses are characterized by both chemical and structural disorder that define their properties. We investigate the behavior of the local, microstructural elastic modulus across the plastic yielding…
The microstructure and mechanical properties of materials saturate to steady states after severe plastic deformation (SPD). Despite the well-known effect of temperature on the steady-state microstructure, there is no general agreement on…
Alumina microplatelets coated with a small amount of Fe3O4 can be oriented via a rotating magnetic field to create texture. After ultrafast high-temperature sintering (UHS), Fe atoms are found at the grain boundaries and within the grains,…
Recently we found that when conventional bulk polycrystalline piezoceramics discs (~ 10 mm diameter) are thinned down to thickness ~ 200 microns or below, the measured unipolar electrostrain (UES) values increased phenomenally…
The atomistic structure of metallic glasses is closely related to properties such as strength and ductility. Here, Ni1-xBx metallic glass nanoparticles of two different sizes are compressed under quasi-hydrostatic high-pressure conditions…
A micromechanical approach is set-up to analyse the increase in elastic stiffness related to development of plastic deformation (the elastoplastic coupling concept) occurring during the compaction of a ceramic powder. Numerical simulations…
The effect of ultrasonic melting processing on three-dimensional architecture of intermetallic phases and pores in two multicomponent cast Al-5.0Cu-0.6Mn-0.5 Fe alloys is characterized using conventional microscopy and synchrotron X-ray…
In this paper, the bulge test is used to determine the mechanical properties of very thin dielectric membranes. Commonly, this experimental method permits to determine the residual stress (s0) and biaxial Young's modulus (E/(1-u)).…
We investigate the impact of the addition of nanoparticles (NP) on the fragility of a model glass-forming polymer melt by molecular dynamics simulations. We find significant changes in fragility for nanoparticle volume fractions $\phi$…
Nanocrystalline metals, i.e. metals in which the grain size is in the nanometer range, have a range of technologically interesting properties including increased hardness and yield strength. We present atomic-scale simulations of the…
Solid solution effects on the strength of the finest nanocrystalline grain sizes are studied with molecular dynamics simulations of different Cu-based alloys. We find evidence of both solid solution strengthening and softening, with trends…
Using molecular dynamics simulations, we investigate the effect of uniaxial elastostatic compression on the potential energy, structural relaxation, and mechanical properties of binary glasses. We consider the three-dimensional Kob-Andersen…
We have performed a study of the magnetic, magnetoelastic, and corrosion resistance properties of seven different composition magnetoelastic-resonant platforms. For some applications, such as structural health monitoring, these materials…
The elastic coupling between plastic events is generally invoked to interpret plastic properties and failure of amorphous soft glassy materials. We report an experiment where the emergence of a self-organized plastic flow is observed well…
We report detailed theoretical investigations of the micro-mechanics and bulk elastic properties of composites consisting of randomly distributed stiff fibers embedded in an elastic matrix in two and three dimensions. Recent experiments…
Al-Mg-Si alloys are utilized in large scale electrical conduction applications thanks to their low density, high strength, and low electrical resistivity. The alloying elements, Mg and Si, are introduced to improve the mechanical strength;…