相关论文: Propagation in 3D of microwaves through density pe…
Turbulent plasma edge density fluctuations can broaden a traversing microwave beam degrading its quality. This can be a problem for scenarios relying on a high spatial localization of the deposition of injected microwave power, like…
Edge plasma density fluctuations are shown to have a significant effect on the electron cyclotron resonance heating (ECRH) beam in the DIII-D tokamak. Experimental measurements of the ECRH deposition profile have been taken in three…
Novel approach for density measurements at the edge of a hot plasma device is presented - Microwave Interferometer in the Limiter Shadow (MILS). The diagnostic technique is based on measuring the change in phase and power of a microwave…
It is not fully understood how electromagnetic waves propagate through plasma density fluctuations when the size of the fluctuations is comparable with the wavelength of the incident radiation. In this paper, the perturbing effect of a…
Theoretical and numerical studies of wave-packet propagation are presented to analyze the time varying 2D mode structures of electrostatic fluctuations in tokamak plasmas, using general flux coordinates. Instead of solving the 2D wave…
The propagation of microwaves across a turbulent plasma density layer is investigated with full-wave simulations. To properly represent a fusion edge-plasma, drift-wave turbulence is considered based on the Hasegawa-Wakatani model.…
Interaction between microwave power, used for local heating and mode control, and density fluctuations can produce a broadening of the injected beam, as confirmed in experiment and simulation. Increased power deposition width could impact…
The propagation of radio frequency (RF) waves in tokamaks can be affected by filamentary structures present in the edge plasma. The waves are reflected, refracted, and diffracted, leading to a decrease in efficiency of heating and/or…
Multi-machine empirical scaling predicts an extremely narrow heat exhaust layer in future high magnetic field tokamaks, producing high power densities that require mitigation. In the experiments presented, the width of this exhaust layer is…
We present methods for analyzing Beam Emission Spectroscopy (BES) data to obtain the plasma density evolution associated with rapid sawtooth crash events at the DIII-D tokamak. BES allows coverage over a 2-D spatial plane, inherently local…
Tokamak plasmas are confined by a magnetic field that limits the particle and heat transport perpendicular to the field. Parallel to the field the ionised particles can move freely, so to obtain confinement the field lines are "closed" (ie.…
Edge localised modes (ELMs) are a concern for future devices as they can limit the operational lifetime of the divertor. The mitigation of ELMs can be performed by the application of resonant magnetic perturbations (RMPs) which act to…
This paper presents a numerical investigation of isolated filament dynamics in a simulation geometry representative of the scrape-off layer (SOL) of the Mega Amp Spherical Tokamak (MAST) previously studied in [N.R.Walkden et.al, Plasma…
Electromagnetic waves undergo modifications as they propagate through plasma. We present EMPI (ElectroMagnetic-wave Plasma Interaction), a three-dimensional numerical framework designed to simulate the interaction between radio signals and…
The Multifaceted Asymmetric Radiation From the Edge (MARFE) is a critical plasma instability that often precedes density-limit disruptions in tokamaks, posing a significant risk to machine integrity and operational efficiency. Early and…
Radio frequency waves are routinely used in tokamak fusion plasmas for plasma heating, current control, and as well as in diagnostics. These waves are excited by antenna structures placed near the tokamak's wall and they have to propagate…
Electromagnetic (EM) waves/disturbances are typically the best means to understand and analyze an ionized medium like plasma. However, the propagation of electromagnetic waves with frequency lower than the plasma frequency is prohibited by…
A recent experimental observation has shown efficient transport of Mega Ampere of electron currents through aligned carbon nanotube arrays [Phys. Rev Letts. 108, 235005 (2012)]. The result was subsequently interpreted on the basis of…
We present the DustFilaments code, a full sky model for the millimeter Galactic emission of thermal dust. Our model, composed of millions of filaments that are imperfectly aligned with the magnetic field, is able to reproduce the main…
The wavelength and the propagation length of the edge magnetoplasmons, running along the edge of a two-dimensional electron layer in a semiconductor quantum-well structure are theoretically studied as a function of frequency, magnetic…