相关论文: Scalable, Non-Invasive Glucose Sensor Based on Bor…
A diamond anvil cell (DAC) which can generate extremely high pressure of multi-megabar is promising tool to develop a further physics such a high-transition temperature superconductivity. However, electrical transport measurements, which is…
Non-contact temperature sensors are widely used, often utilizing infrared light for temperature measurement. However, specific applications demand non-contact detection, particularly within closed containers containing fluids or gases,…
Controllable atomic-scale quantum systems hold great potential as sensitive tools for nanoscale imaging and metrology. Possible applications range from nanoscale electric and magnetic field sensing to single photon microscopy, quantum…
This work proposes a smartphone video-based approach for the estimation of blood glucose in a non-invasive way. Videos using smartphone camera are collected from the tip of the subjects finger and the frames are subsequently converted into…
In this letter we perform an experimental study of ionic transport and current fluctuations inside individual Carbon Nanotubes (CNT). The conductance exhibits a power law behavior at low salinity, with an exponent close to 1/3 versus the…
Electron mobility due to electron-phonon interaction is investigated for fully fluorinated/hydrogenated zig-zag carbon nanotubes containing one-dimensional alternating chains of carbon atoms with $\pi$-bonds. The behavior of mobility…
We report on microwave operation of top-gated single carbon nanotube transistors. From transmission measurements in the 0.1-1.6 GHz range, we deduce device transconductance gm and gate-nanotube capacitance Cg of micro- and nanometric…
Miniaturized spectrometers hold great promise for in situ, in vitro, and even in vivo sensing applications. However, their size reduction imposes vital performance constraints in meeting the rigorous demands of spectroscopy, including fine…
The aim of this paper is to introduce current advances in technology that could enable the development of fully drinkable and autonomous bio-electronic CMOS sensors in the form of dust particles, capable of identifying the source of a…
This paper presents a comprehensive study on a novel multilayer surface plasmon resonance (SPR) biosensor designed for detecting trace-level toxins in liquid samples with exceptional precision and efficiency. Leveraging the Kretschmann…
This study investigates into the adsorption sensing capabilities of single-walled (5,5) boron nitride nanotubes (BNNTs) towards environmental pollutant gas molecules, including CH2, SO2, NH3, H2Se, CO2 and CS2. Employing a linear…
Several centimeters below the skin lie multiple biomarkers, such as glucose, oxygenation, and blood flow. Monitoring these biomarkers regularly and in a non-invasive manner would enable early insight into metabolic status and vascular…
Nanoelectromechanical systems (NEMS) have generated considerable interest as inertial mass sensors. NEMS resonators have been used to weigh cells, biomolecules, and gas molecules, creating many new possibilities for biological and chemical…
We perform ab initio density functional calculations to study the flow of water, methanol and dimethyl ether through nanotubes of carbon and boron nitride with different diameters and chiralities. The liquids we choose are important…
The adsorption of two different organic molecules cyanidin glucoside (C$_{21}$O$_{11}$H$_{20}$) and TA-St-CA on anatase (101) and (001) nanowires have been investigated using the standard and the range separated hybrid density functional…
We characterize inductors fabricated from ultra-thin, approximately 100 nm wide strips of niobium (Nb) and niobium nitride (NbN). These nanowires have a large kinetic inductance in the superconducting state. The kinetic inductance scales…
By integrating a dielectric microwave resonator with a piezoelectric-based strain device, we develop an in situ strain-tunable microwave spectroscopy technique that enables contactless measurements of superconducting properties under…
A shapeable planar Hall sensor has been fabricated by lift-off a bilayer structure of NiFe(10 nm)/IrMn (8 nm) grown on a Kapton/PDMS substrate without using a buffer layer. The sensor exhibits a magnetic field sensitivity of 0.74…
We examined the potential of antibody-functionalized single-walled carbon nanotube (SWNT) field-effect transistors (FETs) for use as a fast and accurate sensor for a Lyme disease antigen. Biosensors were fabricated on oxidized silicon…
We describe the concept of a dry electrode sensor for biopotential measurement applications (ENOBIO) designed to eliminate the noise and inconvenience associated to the use of electrolytic gel. ENOBIO uses nanotechnology to remove…