相关论文: Morphology and photocatalytic activity of highly o…
Using an organometallic precursor, TiO$_2$ coatings were fabricated on surfaces of quartz, zircon and rutile sands. X ray Diffraction, X ray Fluorescence, UV Vis spectroscopy and surface area measurement were used to characterise support…
Nanostructured TiO2 thin films were prepared by pulsed laser deposition (PLD) on indium doped tin oxide (ITO) substrates. Results from X-ray photoelectron spectroscopy (XPS) show that Ti 2p core level peaks shift toward the lower binding…
This work describes the elaboration of rutile titanium dioxide films with high refractive indices and low scattering by sol-gel process and controlled crystallization. The evolutions of the optical properties and crystalline structure of…
This study reports on the properties of nitrogen doped titanium dioxide $TiO_2$ thin films considering the application as transparent conducting oxide (TCO). Sets of thin films were prepared by sputtering a titanium target under oxygen…
This paper reports on the structural and optical properties of Co-doped TiO2 thin films grown onto (0001) Al2O3 substrates by non-reactive pulsed laser deposition (PLD) using argon as buffer gas. It is shown that by keeping constant the…
Transparent pure and Cu-doped (2.5, 5 and 10 at. %) anatase TiO2 thin films were grown by pulsed laser deposition technique on LaAlO3 substrates. The samples were structurally characterized by X-ray absorption spectroscopy and X-ray…
The ability to control porosity in oxide thin films is one of the key factors that determine their properties. Despite the abundance of dry processes for the synthesis of oxide porous layers, the high porosity range is typically achieved by…
We present a study on the crystallization process of undoped and Ta doped TiO2 amorphous thin films. In particular, the effect of ultra-fast annealing treatments in environments characterized by different oxygen concentrations is…
Ruthenium dioxide (RuO$_2$) thin films were synthesized by Chemical Solution Deposition (CSD) on silicon substrates using only water and acetic acid as solvents. The microstructure, phase-purity, electrical and optical properties as well as…
Supported carbon nanosheets and carbon nanotubes served as sacrificial templates for preparing spacious TiO2 photocatalytic thin films. Amorphous TiO2 was deposited conformally on the carbonaceous template material by atomic layer…
Black TiO2 with/without noble metal has been proposed for visible photocatalyst, still leaving poor catalyst efficiency. Alternatively, phase-mixed TiO2 such as anatase and rutile has been commonly used for visible catalysts with the…
To investigate excess-hydrolysis of titanium alkoxides, TiO2 powders were fabricated from titanium-tetra-isopropoxide using 6:1 and 100:1 H2O:Ti (r) ratios. Powders were dried and fired at a range of temperatures ( up to 800 C).…
A series of W, N codoped TiO2 nanotube arrays with different dopant contents were fabricated by anodizing in association with hydrothermal treatment. The samples were characterized by scanning electron microscopy, X-ray diffraction, X-ray…
In this study we synthesized thin films of titanium oxide doped with thulium and/or ytterbium to modify the incident spectrum on the solar cells. This could be achieved either by photoluminescence up-converting devices, or down-converting…
Among the wide bandgap semiconductors, TiO$_{2}$ is the highly stable and cost-efficient semiconductor used for the different photocatalysis processes like water splitting, chemical waste degradation, anti-micro bacterial activities, and…
The Si based TiO2 thin films were prepared via the combination both of Sol-Gel and Spin-Coating method. The films were sintered at 850 degrees Celsius for half an hour, and the resulting films were characterized by X-ray diffraction (XRD)…
Ruthenium metal and its oxide stand out for their exceptional catalytic activity, stability in Oxygen Evolution Reactions (OER) and electrical conductivity, making them indispensable in electronics and electrocatalysis. In this study,…
Thin films of thulium and ytterbium-doped titanium oxide were grown by metal-organic spray pyrolysis deposition from titanium(IV)oxide bis(acetylacetonate), thulium(III) tris(2,2,6,6-tetramethyl-3,5-heptanedionate) and ytterbium(III)…
High quality optical thin film materials form a basis for on-chip photonic micro- and nano-devices, where several photonic elements form an optical circuit. Their realization generally requires the thin film to have a higher refractive…
We report in situ characterized TiO2 thin-films deposited on optical fiber, having thicknesses in the 20-100nm range, and having enhanced conductivity values of 700S/cm upon interacting with hydrogen. This conductivity was achieved in pure…