相关论文: A combined ultrasonic flow meter and binary vapour…
The mechanical and electrical response of acoustophoretic microfluidic devices attached to an ac-voltage-driven piezoelectric transducer is studied by means of numerical simulations. The governing equations are formulated in a variational…
The High Luminosity LHC (HL-LHC) upgrade requires the planned Inner Tracker (ITk) of the ATLAS detector to tolerate extremely high radiation doses. Specifically, the innermost parts of the pixel system will have to withstand radiation…
ATLAS measurements of the azimuthal anisotropy in lead-lead collisions at $\sqrt{s_{NN}}=2.76$ TeV are shown using a dataset of approximately 7 $\mu$b$^{-1}$ collected at the LHC in 2010. The measurements are performed for charged particles…
We report high-resolution measurements of thermal fluctuations in microwave and mechanical resonators using a dual-channel readout system. The latter comprises a low-noise amplifier, an I/Q-mixer, and a cross-correlator. We discovered that,…
We report on an optimized micro-machined thermal flow-rate sensor as part of an autonomous multi-parameter sensing device for water network monitoring. The sensor has been optimized under the following constraints: low power consumption and…
We have developed a Thomson scattering measurement system for the cascade arc discharge device designed for the plasma window (PW) application study. The PW is one of the plasma application techniques that sustain the steep pressure…
Analytical/quasi-analytical solutions are proposed for a steady, compressible, two-phase flow in mechanical equilibrium in a rectilinear duct subjected to heating followed by cooling. The flow is driven by the pressure ratio between a…
We present an approach to construct position-sensitive silicon detectors with an integrated cooling circuit. Tests on samples demonstrate that a very modest liquid flow very effectively cool the devices up to a power dissipation of over…
Supersonic engine development requires accurate and detailed measurements of fluidic and thermodynamic parameters to optimize engine designs and benchmark computational fluid dynamic (CFD) simulations. Here, we demonstrate that dual…
ATLAS is a multipurpose experiment at the LHC. The tracking system of ATLAS, embedded in a 2 T solenoidal field, is composed of different technologies: silicon planar sensors (pixel and microstrips) and drift-tubes. The procedure used to…
This study extends the flow measurement method initially proposed in [22] to three-dimensional scenarios, addressing the growing need for accurate and efficient non-contact flow measurement techniques in complex hydrodynamic environments.…
We study pressure acoustic propagation in asymmetric spoof-fluid-spoof acoustic waveguides and its potential application in acoustic gas sensors. First, a stable and efficient analytical method is established for fast calculation of the…
This paper describes the measurement of elliptic flow of charged particles in lead-lead collisions at sqrt(s_NN) = 2.76 TeV using the ATLAS detector at the Large Hadron Collider (LHC). The results are based on an integrated luminosity of…
The flow field studied was eight strongly impinging, radially injected jets, into a non-swirling mainstream flow in a cylindrical duct. Our previous paper (Heat Mass Transf. (2020) 56:2285-2302), showed that asymmetry in the solution is…
Pressurized drift-tube chambers are efficient detectors for high-precision tracking over large areas. The Monitored Drift-Tube (MDT) chambers of the muon spectrometer of the ATLAS detector at the Large Hadron Collider (LHC) reach a spatial…
The existing ATLAS Tracker will be at its functional limit for particle fluences of 10^15 neq/cm^2 (LHC). Thus for the upgrades at smaller radii like in the case of the planned Insertable B-Layer (IBL) and for increased LHC luminosities…
Modern particle detectors crucially depend on efficient cooling systems. Two-phase carbon dioxide (CO$_2$) is a suitable solution as a cooling agent. This publication presents the observations and results of investigations of horizontal and…
Ionic liquids have proved to be excellent heat transfer fluids and alternatives to common HTFs used in industries for heat exchangers and other heat transfer equipment. However, its industrial utilization depends on the cost per kg of its…
We report the measurements of elliptic flow $v_{2}$, as well as higher harmonics triangular flow $v_{3}$ and quadrangular flow $v_{4}$, in $\sqrt{s_{_{NN}}} =$ 2.76 TeV Pb--Pb collisions, measured with the ALICE detector. We show that the…
The momentum measurement capability of the ATLAS muon spectrometer relies fundamentally on the intrinsic single-hit spatial resolution of the monitored drift tube precision tracking chambers. Optimal resolution is achieved with a dedicated…