相关论文: Diffusion-emission theory of photon enhanced therm…
The present article reports a comprehensive energy balance analysis of a photon-enhanced thermionic emission (PETE) device when it is used for concentrated solar power (CSP) generation. To this end, we consider a realistic PETE device…
In this study, we innovatively modeled photon-enhanced thermionic emission (PETE) devices, incorporating positive ion injection and bidirectional discharge's effects on the space charge barrier simultaneously. Compared to previous models,…
The selfconsistent model for the temperature dependence of photoconversion efficiency $\eta$ for highly efficient silicon solar cells (SCs) is developed. It is demonstrated that effect of the efficiency decrease due to increasing…
This article proposes a new energy harvesting concept that greatly enhances thermionic power generation with high e ciency by exploiting the near- field enhancement of thermal radiation. The proposed near-field enhanced thermionic energy…
Thermophotovoltaic systems in principle enable utilization of heat that is usually regarded as wasted energy. However, the wavelength selectivity of the thermal emitter required for high efficiencies is rather difficult to control with…
In developing photovoltaic devices with high efficiencies, quantitative determination of the carrier loss is crucial. In conventional solar-cell characterization techniques, however, photocurrent reduction originating from parasitic light…
In this work, a combination of cathode retraction and two-slit emittance measurement technique is proposed as an advanced means to individually modify emittance growth components, specifically, rf injector fringe fields, to isolate and…
The performance of a combined solar photovoltaic (PV) and thermoelectric generator (TEG) system is examined using an analytical model for four different types of commercial PVs and a commercial bismuth telluride TEG. The TEG is applied…
Advances in analytical scanning transmission electron microscopy (STEM) and microelectronic mechanical systems (MEMS) based microheaters have enabled in-situ materials characterization at the nanometer scale at elevated temperature. In…
We develop a new approach to calculate the obtainable limit of photoconversion efficiency of tandem solar cells (SCs) and applied it to SCs with both vertical and lateral designs at AM0 and AM1.5 conditions. To get the maximum efficiency,…
We report the first empirical efficiency measurement of germanium-based thermophotovoltaic devices under high-temperature, high-irradiance conditions using a high view-factor calorimetric setup. Two TPV cell architectures were fabricated on…
3He-rich solar energetic particles (SEPs) are believed to be accelerated in solar flares or jets by a mechanism that depends on the ion charge-to-mass (Q/M) ratio. It implies that the flare plasma characteristics (e.g., temperature) may be…
The operation of photoemission electron sources with wavelengths near the photoemission threshold has been shown to dramatically decrease the minimum achievable photocathode emittance, but at the cost of significantly reduced quantum…
Radiative and non-radiative charge carrier recombination in thin-film diodes plays a key role in determining the efficiency of electronic devices made of next generation semiconductors such as organic, perovskite and nanocrystals. In this…
The development of high-performance electron sources requires theoretical frameworks that accurately link the microscopic electronic properties of cathode materials to their macroscopic photoemission observables. Here, we present a…
The power conversion efficiency of organic solar cells has recently improved beyond 20%. The active layers of these devices comprise of at least two organic semiconductors, forming a type II heterojunction. Hereby, the device performance is…
We analytically derive transfer probabilities and efficiencies for an artificial light-harvesting photosynthetic system, which consists of a ring coupled to a central acceptor. For an incident photon pair, we find near-perfect single…
The increasing need for energy storage solutions to balance variable renewable energy sources has highlighted the potential of Pumped Thermal Electricity Storage (PTES). In this paper, we investigate the trade-offs between model accuracy…
Producing high-brightness and high-charge (>100 pC) electron bunches at blowout regime requires ultrashort laser pulses with high fluence. The effects of laser pulse heating of the copper photocathode are analyzed in this paper. The…
Thermionic emission has been exploited to give rise to the theory of thermionic cooling also known as electron transpiration cooling, which can potentially serve as a powerful and engineerable cooling mode for hypersonic leading edges that…