相关论文: Coaxial Wire Measurements of Ferrite Kicker Magnet…

Each stage of an accelerator system has a limited dynamic range and therefore a chain of stages is required to reach high energy. A combination of septa and kicker magnets is frequently used to inject and extract beam from each stage. The…

Accelerator magnets steer particle beams according to the field integrated along the trajectory over the magnet length. Purpose-wound coils measure these relevant parameters with high precision and complement efficiently point-like…

Warm magnets are magnets that function in normal ambient temperature conditions. These types are mostly using a soft steel yoke for field amplification and either Copper or Aluminium coils or permanent magnets to generate the field. Magnets…

A tightly focused laser beam (laser wire) is used for measurement of transverse electron beam sizes in storage rings and linear colliders. It is assumed that the laser beam does nothing with the electron beam except Compton scatterings…

During the 2011 run of the LHC there was a significant measured temperature increase in the LHC Injection Kicker Magnets (MKI) during operation with 50ns bunch spacing. This was due to increased beam-induced heating of the magnet due to…

An accelerator has limited dynamic range: a chain of accelerators is required to reach high energy. A combination of septa and kicker magnets is frequently used to inject and extract beam from each stage. The kicker magnets typically…

Coaxial wire measurements have provided a simple and effective way to measure the beam coupling impedance of accelerator structures for a number of years. It has been known how to measure the longitudinal and dipolar transverse impedance…

The coaxial wire method is a common and appreciated technique to assess the beam coupling impedance of an accelerator element from scattering parameters. Nevertheless, the results obtained from wire measurements could be inaccurate due to…

The extraction system of CSNS mainly consists of two kinds of magnets: eight kickers and one lambertson magnet. In this paper, firstly, the magnetic test results of the eight kickers were introduced and then the filed uniformity and…

Magnetic materials, both hard and soft, are used extensively in several components of particle accelerators. Magnetically soft iron-nickel alloys are used as shields for the vacuum chambers of accelerator injection and extraction septa;…

The wire scanners are used for a measurement of the very small beam size and the emittance in Accelerator Test Facility (ATF). They are installed in the extraction beam line of ATF damping ring. The extracted beam emittance are ex=1.3x10-9…

The wire method is a more rapid and less costly method to measure impedances of RF components compared to methods using a beam. A setup using a single displaced wire to excite and measure transverse resonant modes in accelerating structures…

Fast wire scanners are today considered as part of standard instrumentation in high energy synchrotrons. The extension of their use to synchrotrons working at lower energies, where Coulomb scattering can be important and the transverse beam…

Here we present designs for a static septum magnet with two adjacent apertures where ideally one aperture has a uniform dipole field and the other zero field. Two designs are considered. One is a true septum magnet with a thin layer of…

A calorimetric detector for minimally disruptive measurements of atomic hydrogen beams is described. The calorimeter measures heat released by the recombination of hydrogen atoms into molecules on a thin wire. As a demonstration, the…

This course introduces conventional magnets used in particle accelerators, focusing on both normal-conducting copper coil magnets and permanent magnets (PMs). It covers magnet classification, design principles, material selection, and…

We study the conductance of an electron interferometer formed in a two dimensional electron gas between a nanostructured quantum contact and the charged tip of a scanning gate microscope. Measuring the conductance as a function of the tip…

Using two-dimensional particle-in-cell simulations, we examine how an externally applied strong magnetic impacts proton acceleration in laser-irradiated solid-density targets. We find that a kT-level external magnetic field can sufficiently…

In this work, quantum gravity effects, which can potentially be measured in magnetometers through the Larmor frequency of atoms in an external magnetic field, are estimated. It is shown that the thermal motion of atoms can, in principle,…

We calculate the interaction kernel K for two-dimensional diffusive electrons. The screening of the Coulomb interaction together with the Fermi statistics induces a spin selection rule for electron-electron scattering so that in leading…