相关论文: A modular synthetic device to calibrate promoters

Electronic circuits are useful tools for studying potential dynamical behaviors of synthetic genetic networks. The circuit models are complementary to numerical simulations of the networks, especially providing a framework for verification…

Compressed sensing (CS) is a signal acquisition paradigm to simultaneously acquire and reduce dimension of signals that admit sparse representation. This is achieved by collecting linear, non-adaptive measurements of a signal, which can be…

In this paper, an architecture designed for electrical measurement of the quality factor of MEMS resonators is proposed. An estimation of the measurement performance is made using PSPICE simulations taking into account the component's…

Robust machine learning for regulatory genomics is studied under biologically and technically induced distribution shifts. Deep convolutional and attention based models achieve strong in distribution performance on DNA regulatory sequence…

Protein function does not solely depend on structure but often relies on dynamical transitions between distinct conformations. Despite this fact, our ability to characterize or predict protein dynamics is substantially less developed…

Polymer composites are ideal candidates for next generation biomimetic soft materials because of their exquisite bottom-up designability. However, the richness of behaviours comes at a price: the need for precise and extensive…

Recording reliably extracellular neural activities isan essential prerequisite for the development of bioelectronicsand neuroprosthetic applications. Recently, a fully differential,2-stage, integrating pre-amplifier was proposed for…

With time, machine learning models have increased in their scope, functionality and size. Consequently, the increased functionality and size of such models requires high-end hardware to both train and provide inference after the fact. This…

The paper presents a novel technique for the design of optimal calibration experiments for a planar anthropomorphic manipulator with n degrees of freedom. Proposed approach for selection of manipulator configurations allows essentially…

This paper presents a new procedure for phase detector measurements that allows the use of generators that share a 10 MHz reference oscillator but do not synchronize in phase, in other words, quasi-synchronized RF generators. The objectives…

This work explores the trade-off between the number of samples required to accurately build models of dynamical systems and the degradation of performance in various control objectives due to a coarse approximation. In particular, we show…

Cells receive a wide variety of cellular and environmental signals, which must be processed combinatorially to generate specific and timely genetic responses. We present here a theoretical study on the combinatorial control and integration…

Score calibration enables automatic speaker recognizers to make cost-effective accept / reject decisions. Traditional calibration requires supervised data, which is an expensive resource. We propose a 2-component GMM for unsupervised…

The optimal placement of measurement devices in electrical power systems is commonly modeled through the power dominating set problem. However, in real-world applications, these devices have limited capacities, leading to a capacitated…

Adaptation of software components is an important issue in Component Based Software Engineering (CBSE). Building a system from reusable or Commercial-Off-The-Shelf (COTS) components introduces a set of problems, mainly related to…

Compressed sensing is a novel technique where one can recover sparse signals from the undersampled measurements. In this paper, a $K \times N$ measurement matrix for compressed sensing is deterministically constructed via multiplicative…

A significant challenge in the development of control systems for diesel airpath applications is to tune the controller parameters to achieve satisfactory output performance, especially whilst adhering to input and safety constraints in the…

At National Institute of Metrological Research (INRIM), an automated setup to calibrate DC Voltage generators, mainly top-level calibrators from 1 mV to 1 kV has been developed. The heart of the setup is an INRIM-built automated fixed…

This paper presents a compression framework for Reservoir Computing that enables systematic design-space exploration of trade-offs among quantization levels, pruning rates, model accuracy, and hardware efficiency. The proposed approach…

This paper proposes a method for calibrating control parameters. Examples of such control parameters are gains of PID controllers, weights of a cost function for optimal control, filter coefficients, the sliding surface of a sliding mode…