相关论文: Current and Shot Noise Measurements in a Carbon Na…

We present measurements of current noise in quantum point contacts as a function of source-drain bias, gate voltage, and in-plane magnetic field. At zero bias, Johnson noise provides a measure of the electron temperature. At finite bias,…

We have studied the current through a carbon nanotube quantum dot with one ferromagnetic and one normal-metal lead. For the values of gate voltage at which the normal lead is resonant with the single available non-degenerate energy level on…

By coupling on chip a carbon nanotube to a quantum noise detector, a superconductor-insulator-superconductor junction, via a resonant circuit, we measure the emission noise of a carbon nanotube quantum dot in the Kondo regime. The signature…

The current emission noise of a carbon nanotube quantum dot in the Kondo regime is measured at frequencies $\nu$ of the order or higher than the frequency associated with the Kondo effect $k_B T_K/h$, with $T_K$ the Kondo temperature. The…

We study the low frequency current correlations of an individual single-walled carbon nanotube at liquid He temperature. We have distinguished two physical regimes -- zero dimensional quantum dot and one dimensional quantum wire -- in terms…

We report on shot noise measurements in carbon nanotube based Fabry-Perot electronic interferometers. As a consequence of quantum interferences, the noise power spectral density oscillates as a function of the voltage applied to the gate…

Using nonequilibrium Green functions and several complementary many-body approximations we calculate shot noise and spin dependent conductance in carbon nanotube semiconducting quantum dot in spin-orbital Kondo regime. We point out on the…

An on-chip detection scheme for high frequency signals is used to detect noise generated by a quantum dot formed in a single wall carbon nanotube. The noise detection is based on photon assisted tunneling in a…

Carbon nanotube (CNT) Josephson junctions in the open quantum dot limit exhibit superconducting switching currents which can be controlled with a gate electrode. Shapiro voltage steps can be observed under radiofrequency current…

The shot noise in the current through a quantum dot is calculated as a function of voltage from the high-voltage, Coulomb blockaded regime to the low-voltage, Kondo regime. Using several complementary approaches, it is shown that the…

We have performed noise measurements on suspended ropes of single wall carbon nanotubes (SWNT) between 1 and 300 K for different values of dc current through the ropes. We find that the shot noise is suppressed by more than a factor 100…

We have used the mechanical motion of a carbon nanotube (CNT) as a probe of the average charge on a quantum dot. Variations of the resonance frequency and the quality factor are determined by the change in average charge on the quantum dot…

Most of the time, electronic excitations in mesoscopic conductors are well described, around equilibrium, by non-interacting Landau quasi-particles. This allows a good understanding of the transport properties in the linear regime. However,…

Current fluctuations related to the discreteness of charge passing through small constrictions are termed shot noise. This unavoidable noise provides both advantages - being a direct measurement of the transmitted particles' charge, and…

The noise spectra associated with correlations of the current through a single level quantum dot, and with the charge fluctuations on the dot, are calculated for a finite bias voltage. The results turn out to be sensitive to the asymmetry…

We have investigated shot noise in a 6-nm-diameter, semiconducting multiwalled carbon nanotube FET at 4.2 K over the frequency range 600 - 950 MHz. We find a transconductance of 3 - 3.5 $\mu$S for optimal positive and negative source-drain…

Experimental investigations of current shot noise in quantum point contacts show a reduction of the noise near the 0.7 anomaly. It is demonstrated that such a reduction naturally arises in a model proposed recently to explain the…

We measure the shot noise of a quantum point-contact using a capacitively coupled InAs double quantum dot as an on-chip sensor. Our measurement signals are the (bidirectional) interdot electronic tunneling rates which are determined by…

The demand for a fast high-frequency read-out of high impedance devices, such as quantum dots, necessitates impedance matching. Here we use a resonant impedance matching circuit (a stub tuner) realized by on-chip superconducting…

We theoretically investigate the current-induced excitation of torsional vibrations in a suspended carbon nanotube (CNT) quantum dot. By considering a CNT clamped between half-metallic ferromagnetic electrodes with an antiparallel…