相关论文: Cost Effective Electronics for Proportional and Dr…

EPECUR experimental setup is aimed at the search of narrow resonant states by precision measurement of differential and total reaction cross sections of pion-nucleon interaction with 1 MeV pion energy steps. In five years passed from the…

A drift chamber readout system of the DIRAC experiment at CERN is presented. The system is intended to read out the signals from planar chambers operating in a high current mode. The sense wire signals are digitized in the 16-channel…

It is proposed to upgrade the endcap time-of-flight (ETOF) of the Beijing Spectrometer III (BESIII) with multi-gap resistive plate chamber (MRPC), aiming at overall time resolution about 80 ps. After the entire electronics system is ready,…

To explore the feasibility of high-precision particle identification using the cluster counting technique for the drift chamber, a dedicated readout electronics system with low noise, high bandwidth, and high sampling rate is required. This…

This paper presents the design and implementation of the front-end electronics and the data acquisition (DAQ) system for readout of multi-wire drift chambers (MWDC). Apart of the conventional drift time measurement the system delivers the…

Operating HADES at the future FAIR SIS-100 accelerator challenges the rate capability of DAQ and electronics. A new, more robust version of front-end electronics needs to be built for the HADES drift chamber system. Due to the…

Study of the elastic scattering can produce a rich information on the dynamics of the strong interaction. The EPECUR collaboration is aimed at the research of baryon resonances in the second resonance region via pion-proton elastic…

Within the international studies of a high energy linear electron positron collider, several groups are developing and testing prototypes for a Linear Collider TPC. This detector is planned to be used as a central part in the tracking…

The proposed Circular Electron Positron Collider (CEPC) imposes new challenges for the vertex detector in terms of pixel size and material budget. A Monolithic Active Pixel Sensor (MAPS) prototype called TaichuPix, based on a column drain…

Cross sections for pi+-p elastic scattering have been measured to high precision, for beam momenta between 800 and 1240 MeV/c, by the EPECUR Collaboration, using the ITEP proton synchrotron. The data precision allows comparisons of the…

The reconstruction of the positron trajectory in the MEG-II experiment searching for the $\mu^+ \to e^+ \gamma$ decay uses a cylindrical drift chamber operated with a helium-isobutane gas mixture. A stable performance of the detector in…

In this paper we describe the performance of a prototype of the High Angle Time Projection Chambers (HA-TPCs) that are being produced for the Near Detector (ND280) upgrade of the T2K experiment. The two HA-TPCs of ND280 will be instrumented…

The MEG-II experiment searches for the lepton flavor violating decay: mu in electron and gamma. The reconstruction of the positron trajectory uses a cylindrical drift chamber operated with a mixture of He and iC4H10 gas. It is important to…

A time projection chamber (TPC) based on a gaseous chamber with micro pixel electrodes (micro-PIC) has been developed for measuring three-dimensional tracks of charged particles. The micro-PIC with a detection area of 10 cm square consists…

The international PEN collaboration aims to obtain the branching ratio for the pion electronic decay $\pi^+ \to e^+\nu_e(\gamma)$, aka $\pi_{e2}$, to a relative precision of $5\times 10^{-4}$ or better. The PEN apparatus comprises a number…

The performance of a small prototype of a cylindrical drift chamber (CDC) used in the COMET Phase-I experiment was studied by using an electron beam. The prototype chamber was constructed with alternating all-stereo wire configuration and…

The increasing interest in environmentally friendly gas mixtures for gaseous particle detectors, especially tetrafluoropropene-based gas mixtures for Resistive Plate Chambers (RPCs), has prompted the need for simulating electron transport…

We developed a prototype time projection chamber using gas electron multipliers (GEM-TPC) for high energy heavy ion collision experiments. To investigate its performance, we conducted a beam test with 3 kinds of gases (Ar(90%)-CH4(10%),…

We have built a high precision (24-bit) data acquisition (DAQ) system with eight simultaneously sampling input channels for the measurement of the electric dipole moment (EDM) of the electron. The DAQ system consists of two main components,…

A front-end readout electronics system has been developed for silicon strip detectors. The system uses an application specific integrated circuit (ASIC) ATHED to realize multi-channel E&T measurement. The slow control of ASIC chips is…