相关论文: Booster Synchrotron Frequency Below Transition
It is important to have experimental methods to estimate the maximum beam intensity for the Fermilab Booster as objective input into long term program commitments. An important existing limit is set by the available rf power. This limit is…
The difference between the rf voltage seen by the beam and the accelerating voltage required to match the rate of change of the Booster magnetic field is used to estimate the energy loss per beam turn. Because the rf voltage (RFSUM) and the…
The match between the Linac beam energy and the energy determined by the bending field of the Booster magnets is crucial for rf capture, beam quality, and the transmission efficiency in a Booster cycle. The observation of the injection…
The synchrotron motion simulator is invented to simulate the longitudinal motion for particles under RF (Radio Frequency) voltage field in a ring accelerator. It is especially used to study the efficiency of adiabatic capture for a booster…
Increasing proton beam power on neutrino production targets is one of the major goals of the Fermilab long term accelerator programs. In this effort, the Fermilab 8 GeV Booster synchrotron plays a critical role for at least the next two…
Understanding the transition-crossing process is crucial for improving Booster performance at high intensity. The synchronous phase appears to drop toward 90 degrees right after transition regardless of beam intensity, more so at higher…
Synchrotron radiation has been used for many years as a beam diagnostic at electron accelerators. It is not normally associated with proton accelerators as the intensity of the radiation is too weak to make detection practical. However, if…
A simplified Doppler frequency shift measurement approach based on Serrodyne optical frequency translation is reported. A sawtooth wave with an appropriate amplitude is sent to one phase modulation arm of a Mach-Zehnder modulator in…
The timing system of SPring-8 booster synchrotron generates various timing signals concerning beam injection, acceleration from 1 GeV to 8 GeV and ejection. We have improved the timing system of the synchrotron giving it better stability…
Plasma scattering measurement is effective technique to observe low frequency density fluctuations excited in plasma. The spatial and wave number resolutions and the S/N ratio of measurement depend on the wavelength range, the size and the…
The quality of energy produced in renewable energy systems has to be at the high level specified by respective standards and directives. The estimation accuracy of grid signal parameters is one of the most important factors affecting this…
Any frequency selective device with an ongoing drift will cause observed spectra to be variously and simultaneously scaled in proportion to their source distances. The reason is that detectors after the drifting selection will integrate…
If we try to measure the backward optical diffraction radiation (BODR) of high energy electrons from a conductive slit or a semi infinitive plate, the electron beam will pass thru the bending or steering magnets or magnet lenses before…
The so-called Spectral Curvature Parameter(SCP), when plotted versus the high-frequency spectral index ($alpha_{high}$) of synchrotron sources, provides crucial parameters on the continuum spectrum of synchrotron radiation without the more…
A techniques, describing electron dynamics for magnetic models closed to cyclical accelerators, is developed and applied to the analysis of electromagnetic radiation emitted by charged particles. Formulas for the angular characteristics of…
The low-level RF system (LLRF) generates the drive sent to the high-power equipment. In synchrotrons, it uses signals from beam pick-ups (radial and longitudinal) to minimize the beam losses and provide a beam with reproducible parameters…
Detrimental beam dynamics effects limit performance of high intensity rapid cycling synchrotrons (RCS) such as the 8 GeV proton Fermilab Booster. Here we report the results of comprehensive experimental studies of various beam intensity…
High-power hadron accelerators have strict limits on fractional beam loss. In principle, once a high-quality beam is set up in an acceptable state, beam loss should remain steady. However, in practice, there are many trips in operational…
The control of beam phase relative to the accelerating RF field within a superconducting cavity is important in many accelerator applications and is of particular importance for a free electron laser facility. As standard practice, the…
We introduce the first method to enable an optical amplification of a coherent Raman spectroscopy signal called radio frequency Doppler Raman spectroscopy. Doppler Raman measurements amplify the optical signals in coherent Raman…