相关论文: Status Report on Multi-Cell Superconducting Cavity…

We report the fabrication of a 1.2 cm long cavity directly on a nanofiber using femtosecond laser ablation. The cavity modes with finesse value in the range 200-400 can still maintain the transmission between 40-60%, which can enable…

Superconducting radio-frequency cavities are commonly used in modern particle accelerators for applied and fundamental research. Such cavities are typically made of high-purity, bulk Nb and are cooled by a liquid helium bath at a…

The proposed linear electron-positron collider TESLA is based on 1.3 GHz superconducting niobium cavities for particle acceleration. For a centre-of-mass energy of 500 GeV, an accelerating field of 23.4 MV/m is required which is reliably…

The research note presents results of coupled RF and thermal simulation of a cryocooler conduction cooled 650 MHz SRF cavity made of bulk niobium and coated with Nb3Sn on the RF surface. The cavity is part of a particle accelerator design…

Radio frequency (RF) superconductivity has become a key technology for many modern particle accelerators. One of its most salient features of this technology is the ability of superconducting RF cavities to deliver high accelerating…

Three-dimensional microwave cavities have recently been combined with superconducting qubits in the circuit quantum electrodynamics (cQED) architecture. These cavities should have less sensitivity to dielectric and conductor losses at…

Superconducting cavities with low RF frequencies and heavy damping of higher order modes (HOM) are desired for the main accelerator of High Energy Photon Source (HEPS), a 6 GeV synchrotron light source promising ultralow emittance currently…

The higher efficiency of superconducting radio-frequency (SRF) cavities compared to normal-conducting ones enables the development of high-energy continuous-wave linear accelerators (linacs). Recent progress in the development of…

In dark matter searches using axion haloscopes, the search sensitivity depends on the quality factors ($Q_0$) of radiofrequency cavities immersed in multi-tesla magnetic fields. Increasing $Q_0$ would increase the scan rate through the…

As a result of a collaboration between Jefferson Lab and niobium manufacturer CBMM, ingot niobium was explored as a possible material for superconducting radiofrequency (SRF) cavity fabrication. The first single cell cavity from large grain…

The observation of superconductivity at 4.3 K in a new crystalline form of Na0.3CoO2*1.3H2O is reported. The new superconductor has three layers of CoO6 octahedra per crystallographic unit cell, in contrast to the previously reported…

The article considers a proton accelerator containing seven independent beams arranged on the accelerator radius. The current in each beam is one hundred milliamps. The initial part of the accelerator consists of shielded spiral waveguides…

Recently, heat treatment between 250 C and 500 C has been attempted to improve quality factor of superconducting radio-frequency cavities at FNAL and KEK. Experiments of such medium temperature (mid-T) bake with furnaces have also been…

A novel design of superconducting Crab Cavity was proposed and designed at Brookhaven National Laboratory. The new cavity shape is a Double Quarter Wave or DQWCC. After fabrication and surface treatments, the niobium proof-of-principle…

Room temperature IH-type drift tube structures are used at different places now for the acceleration of ions with mass over charge ratios up to 65 and velocities between 0.016 c and 0.1 c. These structures have a high shunt impedance and…

In cavities, there exists not only the fundamental mode which is used to accelerate the beam but also higher order modes (HOMs). The higher order modes excited by beam can seriously affect beam quality, especially for the higher R/Q modes.…

A deterministic design of an ultrahigh Q, wavelength scale mode volume photonic crystal nanobeam cavity is proposed and experimentally demonstrated. Using this approach, cavities with Q>10^6 and on-resonance transmission T>90% are designed.…

Superconducting microwave cavities with ultra-high Q-factors are revolutionizing the field of quantum computing, offering long coherence times exceeding 1 ms, which is critical for realizing scalable multi-qubit quantum systems with low…

Three-dimensional (3D) superconducting microwave cavities with large mode volumes typically have high quality factors ($>10^6$). This is due to a reduced sensitivity to surface dielectric losses, which is the limiting source of dissipation…

A 325MHz beta=0.14 superconducting half wave resonator(HWR) prototype has been developed at the Institute of High Energy Physics(IHEP), which can be applied in continuous wave (CW) high beam proton accelerators. In this paper, the…