相关论文: Meeting Tight Frequency Requirement of Rounded Dam…

Following the successful design and fabrication of Damped Detuned Structures (DDS), the JLC/NLC linear collider project advanced to Rounded Damped Detuned Structures (RDDS) with curved cross section of the cavity shape for increased shunt…

As a joint effort in the JLC/NLC research program, we have developed a new type of damped detuned accelerator structure with optimized round-shaped cavities (RDDS). This paper discusses some important R&D aspects of the first structure in…

A damped detuned structure for the main X-band linacs of CLIC is being investigated as an alternative design to the present baseline heavily damped structure. In our earlier designs we studied detuned structures, operating at 11.994 GHz,…

Recent experiments at SLAC [1,2] and CERN [3] have revealed evidence of significant deformation in the form of "pitting" of the cells of the 1.8m series of structures DDS/RDDS (Damped Detuned Structure/Rounded Damped Detuned Structure).…

The main accelerating structures for the CLIC are designed to operate at an average accelerating gradient of 100 MV/m. The accelerating frequency has been optimised to 11.994 GHz with a phase advance of 2{\pi}/3 of the main accelerating…

It has been technically challenging to efficiently couple external radiofrequency (RF) power to cylindrical dielectric-loaded accelerating (DLA) structures, especially when the DLA structure has a high dielectric constant. This paper…

The complexity of the Round Damped Detuned Structue (RDDS) for the JLC/NLC main linac is driven by the considerations of rf efficiency and dipole wakefield suppression. As a time and cost saving measure for the JLC/NLC, the dimensions of…

In fabricating the first X-Band RDDS (Rounded Damped Detuned Structure) accelerator structure, microwave measurements are made on short groups of discs prior to bonding the discs of the entire structure. The design dispersion curves are…

Earlier RDDS (Rounded Damped Detuned Structures) [1,2], designed, fabricated and tested at SLAC, in collaboration with KEK, have been shown to damp wakefields successfully. However, electrical breakdown has been found to occur in these…

In the JLC/NLC X-band linear collider, it is essential to reduce the long-range dipole wakefields in the accelerator structure to prevent beam break up (BBU) and emittance degradation. The two methods of reducing the long-range wakefields…

The millimeter wave all-metallic accelerating structure, aimed to provide more than 100 MeV/m gradient and fed by feeding RF pulses of 20-30 ns duration, is proposed. The structure is based on a waveguide with small helical corrugation.…

The wire method is a more rapid and less costly method to measure impedances of RF components compared to methods using a beam. A setup using a single displaced wire to excite and measure transverse resonant modes in accelerating structures…

We report frequency and dissipation scaling laws for doubly-clamped diamond resonators. The device lengths range from 10 microns to 19 microns corresponding to frequency and quality-factor ranges of 17 MHz to 66 MHz and 600 to 2400…

Frequency crowding remains a major obstacle to scaling fixed-frequency transmon processors. Among the widely used all-microwave two-qubit gates, the cross-resonance (CR) gate is particularly sensitive to qubit-frequency spread because the…

Dielectric-loaded accelerating (DLA) structures are being studied as an alternative to conventional disk-loaded copper structures to produce the high accelerating gradient. This paper presents the design, fabrication and low-power RF…

Dielectric disk accelerating (DDA) structures are being studied as an alternative to conventional disk-loaded copper structures. This paper investigates numerically an efficient X-band DDA structure operating at a higher order mode of…

We have developed high-efficiency normal-conducting RF accelerating structures by combining H-mode resonator cavities and a transverse beam focusing by permanent-magnet quadrupoles (PMQ), for beam velocities in the range of a few percent of…

Operating the SLAC/KEK DDS (Damped Detuned Structure) X-band linacs at high gradients (in excess of 70MV/m) has recently been found to be limited by the accelerator structures breaking down and as a consequence severe damage occurs to the…

Rapid acceleration and burst maneuvers in underwater robots depend less on maintaining precise resonance and more on force--velocity phase alignment during thrust generation. In this work, we investigate constrained-layer damping (CLD) as a…

In the NLC (Next Linear Collider) small misalignments in each of the individual accelerator structures (or the accelerator cells) will give rise to wakefields which kick the beam from its electrical axis. This wakefield can cause BBU (Beam…