相关论文: Monolithic Geometric Anti-Spring Blade
Low-phase-noise microwave-frequency integrated oscillators provide compact solutions for various applications in signal processing, communications, and sensing. Surface acoustic waves (SAW), featuring orders-of-magnitude shorter wavelength…
This paper explores the interaction of weak gravitational fields with slender elastic materials in space and estimates their sensitivities for the detection of gravitational waves with frequencies between $10^{-4}$ and 1 Hz. The dynamic…
A detailed analysis of the most relevant sources of phase noise in an atomic interferometer is carried out, both theoretically and experimentally. Even a short interrogation time of 100 ms allows our cold atom gravimeter to reach an…
We present a performance analysis of compact monolithic optomechanical inertial sensors that describes their key fundamental limits and overall acceleration noise floor. Performance simulations for low frequency gravity-sensitive inertial…
Current terrestrial gravitational-wave detectors operate at frequencies above 10 Hz. There is strong astrophysical motivation to construct low-frequency gravitational-wave detectors capable of observing 10 mHz - 10Hz signals. While…
The observed microwave background anisotropies in combination with the theory of quantum mechanically generated cosmological perturbations predict a well measurable amount of relic gravitational waves in the frequency intervals tested by…
Higher-order Laguerre-Gauss (LG) modes have previously been investigated as a candidate for reducing test-mass thermal noise in ground-based gravitational-wave detectors like Advanced LIGO. It has been shown however that LG modes' fragility…
This paper presents a detailed noise analysis and a noise-based optimization procedure for resonant MEMS structures. A design for high sensitivity of MEMS structures needs to take into account the noise shaping induced by damping phenomena…
Seismic noise will be the dominant source of noise at low frequencies for ground based gravitational wave detectors, such as LIGO now under construction. Future interferometers installed at LIGO plan to use at least a double pendulum…
Sagnac speed meter (SSM) topology is known as an alternative technique to reduce quantum back-action in gravitational-wave interferometers. However, any potential imbalance of the main beamsplitter was shown to reduce the quantum noise…
Atomic force microscopy is an important tool for characterizing surface acoustic waves, in particular for high frequencies, where the wavelength is too short to be resolved by laser interferometry. A caveat is, that the cantilever…
Telegraphic noise is one of the most significant problems that arises when making sensitive measurements with lateral electrostatic devices. In this paper we demonstrate that a wafer which had only produced devices with significant…
The selection of sites for underground gravitational wave detectors based on spectral and cumulative characterisation of the low frequency seismic noise. The evaluation of the collected long term seismological data in the M\'atra…
Navigation, bio-tracking devices and gravity gradiometry are amongst the diverse range of applications requiring ultrasensitive measurements of acceleration. We describe an accelerometer that exploits the dispersive and dissipative coupling…
The so-called Locally Resonant Acoustic Metamaterials (LRAM) are considered for the design of specifically engineered devices capable of stopping waves from propagating in certain frequency regions (bandgaps), this making them applicable…
Unlike ground-based interferometric gravitational wave detectors, large space-based systems will not be rigid structures. When the end-stations of the laser interferometer are freely flying spacecraft, the armlengths will change due to…
Laser frequency stabilization is notably one of the major challenges on the way to a space-borne gravitational wave observatory. The proposed Laser Interferometer Space Antenna (LISA) is presently under development in an ESA, NASA…
The Juggled interferometer (JIFO) is an earth-based gravitational wave detector using repeatedly free-falling test masses. With no worries of seismic noise and suspension thermal noise, the JIFO can have much better sensitivity at lower…
Low mechanical loss materials are needed to further decrease thermal noise in upcoming gravitational wave detectors. We present an analysis of the contribution of Akhieser and thermoelastic damping on the experimental results of resonant…
We propose two distinct atom interferometer gravitational wave detectors, one terrestrial and another satellite-based, utilizing the core technology of the Stanford $10 \text{m}$ atom interferometer presently under construction. The…