相关论文: RF Surface Resistance of a HIPped MgB2 Sample at 2…

In this paper, we apply the two-band extension [1] of BCS theory [2] into the Mattis-Bardeen theory [3] to obtain the surface impedance of a two-band superconductor, and apply it to magnesium diboride (MgB2) for radiofrequency (RF)…

We have performed microwave measurements on superconducting hot-isostatically- pressed (HIPed) bulk MgB2 using a parallel-plate resonator technique. The high density and strength of the HIPed material allowed preparation of samples with…

The microwave surface resistance Rs of MgB2 films with the zero-resistance temperature of - 39 K was measured at 8.0 - 8.5 GHz. The MgB2 films were prepared by deposition of boron films on c-cut sapphire, followed by annealing in a…

We report on the microwave (mw) properties of coaxial cavities built by using bulk MgB2 superconductor prepared by reactive liquid Mg infiltration technology. We have assembled a homogeneous cavity, by using an outer MgB2 cylinder and an…

In order to increase the accelerating gradient of Superconducting Radio Frequency (SRF) cavities, Magnesium Diboride (MgB2) opens up hope because of its high transition temperature and potential for low surface resistance in the high RF…

The new superconductor MgB2 may prove useful for microwave applications at intermediate temperatures. MgB2 films with the thickness of 300 - 400 nm have surface resistance Rs less than 0.01 mOhms at a frequency (f) of 8.5 GHz and 7 K,and ~…

Measurements of the $10GHz$ microwave surface resistance of dense $MgB_{2}$ wire and pellet are reported. Significant improvements are observed in the wire with reduction of porosity. The data lie substantially above the theoretical…

The performance of superconducting radio-frequency (SRF) cavities made of Niobium is tied to the quality of their inner surfaces exposed to the radio frequency (RF) waves. Future superconducting particle accelerators, because of their…

Carbon-doped magnesium diboride was fabricated from pre-reacted pure MgB2 by mechanical alloying. The sample set had excellent critical current densities Jc(8T,4.2K) ranging from 15-60 kA/cm2, depending on composition. Magneto-optical…

Measurements of the temperature dependence of the surface resistance at 3 GHz of 100 micron size grains of MgB_2 separated powder are presented and discussed. The microwave surface resistance data is compared to experimental results of Nb,…

Porous magnesium diboride samples have been prepared by the heat treatment of a pressed mixture of Mg and MgB2 powders. It was found that linked superconducting structure is formed down to the minimum normalized density gamma= d/do= 0.16…

We have developed a low temperature, high-resolution microwave surface impedance probe that is able to operate in high static magnetic fields. Surface impedance is measured by cavity perturbation of dielectric resonators, with sufficient…

Two issues related to the microwave surface impedance Z_s of MgB_2 thin film are discussed in this Letter, both being significant for potential microwave applications. At first, a correlation between Zs and Alpha = Xi/l was found, where Xi…

A relatively high critical temperature, Tc, approaching 40 K, places the recently-discovered superconductor magnesium diboride (MgB2) intermediate between the families of low- and copper-oxide-based high-temperature superconductors (HTS).…

We report on an effort to improve the performance of superconducting radiofrequency cavities by the use of heat treatment in a temperature range sufficient to dissociate the natural surface oxide. We find that the residual resistance is…

We discuss the temperature, frequency, and power-dependent surface resistance of the boride superconductor MgB2 in relation to possible applications for passive microwave devices. The data available in the literature are compared with…

We present a study of the electrodynamic response of MgB2 pellets and thin film samples exhibiting critical temperatures ranging between 26 and 38 K. We have performed accurate measurements of the surface impedance ZS =RS+iXS as a function…

Nb3Sn (Tc ~ 18 K and Hsh ~ 400 mT) is a prospective material to replace Nb (Tc ~ 9 K and Hsh ~ 200 mT) in SRF accelerator cavities for significant cost reduction and performance enhancement. Because of its material properties, Nb3Sn is best…

We have successfully deposited thick MgB2 film on the (0001) crystalline surface of sapphire by the method of hybrid physical-chemical vapor deposition (HPCVD). The film thickness is about 1.3 micron. It has a dense and interlaced…

Surface resistance of HTS films is typically measured using Sapphire dielectric rod resonators enclosed in a copper cavity. In this paper we present surface resistance measurements of YBa2Cu3O7-{\delta} films using Strontium Lanthanum…