相关论文: Experimental Comparison of Local and Over-the-Air …
Channel measurements in MIMO systems hinge on precise synchronization. While methods for time and frequency synchronization are well established, maintaining real-time phase coherence remains an open requirement for many MIMO systems. Phase…
Phase synchronization among distributed transmission reception points (TRPs) is a prerequisite for enabling coherent joint transmission and high-precision sensing in millimeter wave (mmWave) cell-free massive multiple-input and…
To avoid the unpredictable phase deviations of the spaceborne phased array (SPA), this paper considers the over-the-air (OTA) phase calibration of the SPA for the low earth orbit (LEO) satellite communications, where the phase deviations of…
Phase synchronization of access points (APs) in a distributed multiple-input multiple-output (D-MIMO) system is critical to leverage the performance benefits of D-MIMO. Existing over-the-air phase synchronization methods assume that APs can…
The fundamental mechanism driving MIMO beamforming is the relative phases of signals departing the transmit array and arriving at the receive array. If a propagation channel affects all transmitted signals equally, the relative phases are a…
In MIMO systems, the presence of phase noise is a significant factor that can degrade performance. For MIMO testbeds build from SDR devices, phase noise cannot be ignored, particular in applications that require phase synchronization. This…
Accurate localization in Orthogonal Frequency Division Multiplexing (OFDM)-based massive Multiple-Input Multiple-Output (MIMO) systems depends critically on phase coherence across subcarriers and antennas. However, practical systems suffer…
Massive multiple-input multiple-output (MIMO) promises significantly higher performance relative to conventional multiuser systems. However, the promised gains of massive MIMO systems rely heavily on the accuracy of the absolute front-end…
Downlink coherent multiuser transmission is an essential technique for cell-free massive multiple-input multiple output (MIMO) systems, and the availability of channel state information (CSI) at the transmitter is a basic requirement. To…
Reciprocity-based, joint coherent downlink beamforming from multiple access points (APs) in distributed multiple-input multiple-output (MIMO) with independent local oscillators (LOs) requires the APs to be periodically phase-calibrated…
Synchronization of transceiver chains is a major challenge in the practical realization of massive MIMO and especially distributed massive MIMO. While frequency synchronization is comparatively easy to achieve, estimating the carrier phase…
Distributed multiple-input multiple-output (MIMO) architectures enable large-scale integrated sensing and communication (ISAC) by providing high spatial resolution and robustness through spatial diversity. However, practical phase-coherent…
One of the biggest challenges in operating massive multiple-input multiple-output systems is the acquisition of accurate channel state information at the transmitter. To take up this challenge, time division duplex is more favorable thanks…
Non-linear transceivers and non-reciprocity of downlink and uplink channels are two major challenges in the deployment of massive multiple-input-multiple-output (MIMO) systems. We consider an over-the-air (OTA) approach for digital…
Embodying the principle of simulation intelligence, digital twin (DT) systems construct and maintain a high-fidelity virtual model of a physical system. This paper focuses on ray tracing (RT), which is widely seen as an enabling technology…
In this paper, a rigorous link performance test for MIMO OTA (multiple-input-multiple-output over-the-air) characterisation with traceable signal-to-interference-plus-noise ratio (SINR) is presented. Measurements were made with three…
The large beamforming gain used to operate at millimeter wave (mmWave) frequencies requires obtaining channel information to configure hybrid antenna arrays. Previously proposed wideband channel estimation strategies, however, assume…
Measurement results for millimeter wave LOS MIMO systems are presented with a focus on time variation and multipath propagation. Different system setups are used, including 2x2 and 3x3 MIMO, and involving different synchronization…
This paper proposes a channel estimation method for hybrid wideband multiple-input-multiple-output (MIMO) systems in high-frequency bands, including millimeter-wave (mmWave) and sub-terahertz (sub-THz), in the presence of beam squint…
As the demand for 6G technologies continues to grow, the radio access infrastructure is expected to become increasingly dense. Cell-free (CF) Massive MIMO systems provide remarkable flexibility by enabling coherent service to users through…