相关论文: A Reconfigurable Circuit Strategy and Its Applicat…
This letter presents a novel adaptive power division strategy, which uses two rectifying diodes with nonlinear impedance characteristics that are configured in parallel to function optimally at their individual power levels. Through the…
Carbon nanotube Schottky diodes have been fabricated in an all-photolithographic process using dissimilar contact metals on high-frequency compatible substrates (quartz and sapphire). Diodes show near-ideal behavior, and rectify currents of…
Spin-diodes are usually resonant in nature (GHz frequency) and tuneable by magnetic field and bias current with performances, in terms of sensitivity and minimum detectable power, overcoming the semiconductor counterpart, i.e. Schottky…
This letter presents the design and implementation of a compact high-efficiency octave microwave rectifier. A key highlight is the novel segmented impedance matching method, a unique approach that expands the rectifier bandwidth. The diode…
A rectenna (rectifying antenna) is usually applied to a microwave power transmission (MPT) system as a terminal, which receives microwave (MW) power and converts them into DC power. A 5.8 GHz aperture-coupled patch antenna array is…
Voltage doubler rectifiers are usually applied to systems with high voltage and low current requirement. An X band voltage doubler rectifier has been developed with 72% conversion efficiency. To the best of our knowledge, the obtained…
We demonstrate an RF energy harvesting rectenna design based on a metamaterial perfect absorber (MPA). With the embedded Schottky diodes, the rectenna converts captured RF waves to DC power. The Fabry-Perot (FP) cavity resonance of the MPA…
Harmonic generation during radio frequency (RF)-dc conversion causes performance degradation of a microwave rectifying circuit. To suppress and recycle the harmonic power, this letter proposes a novel compact dual-band resonator (DBR) based…
In this paper, we present techniques and examples to reduce power consumption and increase energy efficiency of autonomous Wireless Sensor Nodes (WSNs) for the Internet of Things. We focus on the RF Energy Harvester (RFEH), the data…
A low-cost reconfiguration stage connected at the output of balanced three-phase, multi-terminal ac/dc/ac converters can increase the feasible set of power injections substantially, increasing converter utilization and therefore achieving a…
Electrical current rectification is an interesting electronic feature, popularly known as a diode. Achieving a high rectification ratio in a molecular junction has been a long-standing goal in molecular electronics. The present work…
Superconducting electronics is essential for energy-efficient quantum and classical high-end computing applications. Towards this goal, non-reciprocal superconducting circuit elements, such as superconducting diodes (SDs) can fulfill many…
A microwave rectifier at 5.8 GHz without any capacitors is presented, which owns a measured MW-to-DC conversion efficiency of 68.1%. A harmonic rejection filter and a DC pass filter, which replace lumped capacitors in conventional microwave…
We numerically demonstrate a new type of waveform-selective metasurface that senses the difference in incoming waveforms or pulse widths at the same frequency. Importantly, the proposed structure contains precise rectifier circuits that,…
Superconducting thin-film electronics are attractive for their low power consumption, fast operating speeds, and ease of interface with cryogenic systems such as single-photon detector arrays, and quantum computing devices. However, the…
This paper presents the design and analysis of a superdirective rectenna optimized for enhanced RF-to-DC efficiency and realised gain, featuring direct impedance matching between the antenna and the rectifier. Employing passively loaded,…
Piezoelectric energy harvester scavenges mechanical vibrations and generates electricity. Researchers have strived to optimize the electromechanical structures and to design necessary external power management circuits, aiming to deliver…
We report on a new type of rectifier which is in full contact equilibrium and thus, if down-sized to the nanoscale, shows no drift even if exposed to elevated temperatures and/or extreme waiting times. This is in contrast to existing diodes…
This paper presents an efficient dual-band rectifier for radiofrequency energy harvesting (RFEH) applications at FM and GSM bands. The single-port rectifier circuit, which comprises a 3-port network, optimized T-matching circuits and…
We demonstrate a top-down fabricated reconfigurable field effect transistor (RFET) based on a silicon nanowire that can be electrostatically programmed to p- and n-configuration. The device unites a high symmetry of transfer…