相关论文: Impedance Modeling of Magnetometers: A Path Toward…
Due to the need for higher reliability and performance from RF circuits, multi-port reflectometers are increasingly used as low-overhead impedance monitors. In this work, using periodic structures as multi-ports is proposed. Periodic…
A high accuracy and high sensitivity system architecture is proposed for the read-out circuit of electrical impedance tomography system-on-chip. The switched ratiometric technique is applied in the proposed architecture. The proposed system…
The two high-angle Time Projection Chambers of the T2K experiment are equipped with a new readout system based on resistive Micromegas detector technology, and utilize custom-made electronics based on AFTER chips for signal processing. This…
Today's mechanical sensors are capable of detecting extremely weak perturbations while operating near the standard quantum limit. However, further improvements can be made in both sensitivity and bandwidth when we reduce the noise…
The small-signal impedance modeling of modular multilevel converter (MMC) is the key for analyzing resonance and stability of MMC-based ac power electronics systems. MMC is a converter system with a typical multi-frequency response due to…
This paper presents realistic system-level modelling and simulation of effective noise sources in a coupled resonating MEMS sensors. A governing set of differential equations are used to build a numerical model of a mechanical noise source…
We report the demonstration of a magnetometer with noise-floor reduction below the shot-noise level. This magnetometer, based on a nonlinear magneto-optical rotation effect, is enhanced by the injection of a squeezed vacuum state into its…
Here a minimum power dissipation coil transducer has been designed to allow in-flight noise characterization of a low-frequency magnetic measurement system. The coil was produced using PCB technology to provide mechanical stability and easy…
Magnetoelectric (ME) magnetic field sensors commonly rely on one of the two modulation principles: the nonlinear dependence of magnetostrictive strain on the applied field or the stress-induced change in magnetization susceptibility. While…
An experimentally feasible magnetometer based on a dual-coupling optomechanical system is proposed, where the radiation-pressure coupling transduces the magnetic signal to the optical phase, and the quadratic optomechanical interaction…
This work investigates the behavior of a spin-exchange relaxation-free (SERF) magnetometer integrated into the feedback branch of a closed-loop control circuit, designed to actively suppress noise from a current source. In this…
Fault-tolerant quantum information processing with flawed qubits and gates requires highly efficient, quantum non-demolition (QND) qubit readout. In superconducting circuits, qubit readout using coherent light with fidelity above 99% has…
Magneto-mechanical resonators (MMRs) represent a recently proposed type of passive sensor that enables the estimation of its pose as well as sensing other parameters in its environment. The working principle of MMRs entails an excitation of…
This article presents several design techniques to fabricate micro-electro-mechanical systems (MEMS) using standard complementary metal-oxide semiconductor (CMOS) processes. They were applied to fabricate high yield CMOS-MEMS shielded…
The recent excitement about Dirac and Weyl fermion systems has renewed interest in magnetotransport properties of multi-carrier systems. However, the complexity of their analysis, even in the simplest two-carrier case, has hampered a good…
This paper proposes a theoretical modelling of the simultaneous and non invasive measurement of electrical resistivity and dielectric permittivity, using a quadrupole probe on a subjacent medium. A mathematical-physical model is applied on…
Modeling of Li-ion cells is used in battery management systems (BMS) to determine key states such as state-of-charge (SoC), state-of-health (SoH), etc. Accurate models are also useful in developing a cell-level digital-twin that can be used…
In gate-defined quantum dot systems, the conductance change of electrostatically coupled sensor dots allows the observation of the quantum dots' charge and spin states. Therefore, the sensor dot must be optimally sensitive to changes in its…
We present recent results on two attempts at understanding and utilizing large-scale simulations of magnetic materials. In the first study we consider massively parallel implementations on a Cray T3E of the n-fold way algorithm for…
Making use of coherence and entanglement as metrological quantum resources allows to improve the measurement precision from the shot-noise- or quantum limit to the Heisenberg limit. Quantum metrology then relies on the availability of…