相关论文: On the Existence of Prewetting in Supracritical Fl…

We report the observation of a premelting transition at chemically sharp solid-liquid interfaces using molecular-dynamics simulations. The transition is observed in the solid-Al/liquid-Pb system and involves the formation of a liquid…

We look at the wetting of a pure fluid in contact with a charged flat surface. In the bulk, the fluid is a classical van der Waals fluid containing dissociated ions. The presence of wall and ions leads to strong dielectrophoretic and…

Some fluids exhibit anomalously low friction when flowing against a certain solid wall. To recover the viscosity of a bulk fluid, slip at the wall is usually postulated. On a macroscopic level, a large slip length can be explained as a…

For wetting films in dilute electrolyte solutions close to charged walls we present analytic expressions for their effective interface potentials. The analysis of these expressions renders the conditions under which corresponding wetting…

We present the first microscopic images of the prewetting transition of a liquid film on a solid surface. Pictures of the local coverage map of a helium film on a cesium metal surface are taken while the temperature is raised through the…

We calculate various thermodynamic quantities of vortex liquids in a layered superconductor by using the nonperturbative parquet approximation method, which was previously used to study the effect of thermal fluctuations in two-dimensional…

In simulations of a water-like model (ST2) that exhibits a liquid-liquid phase transition, we test for the occurrence of a thermodynamic region in which the liquid can be modelled as a two-component mixture. We assign each molecule to one…

The behavior of a confined spherical symmetric anomalous fluid under high external pressure was studied with Molecular Dynamics simulations. The fluid is modeled by a ore-softened potential with two characteristic length scales, which in…

We examine the profile of a liquid front of a film that is dewetting a solid substrate. Since volume is conserved, the material that once covered the substrate is accumulated in a rim close to the three phase contact line. Theoretically,…

We study the wetting behaviour of a symmetrical binary fluid below the demixing temperature at a non-selective attractive wall. Although it demixes in the bulk, a sufficiently thin liquid film remains mixed. On approaching liquid/vapour…

Polymorphism is ubiquitous in crystalline solids. Amorphous solids, such as glassy water and silicon, may undergo amorphous-to-amorphous transitions (AATs). The nature of AATs remains ambiguous, due to diverse system-dependent behaviors and…

Liquid polymorphism is an intriguing phenomenon which has been found in a few single-component systems, the most famous being water. By supercooling liquid Te to more than 130 K below its melting point and performing simultaneous…

We present a phenomenological model of melting in nanoparticles with facets that are only partially wet by their liquid phase. We show that in this model, as the solid nanoparticle seeks to avoid coexistence with the liquid, the…

A coarse-grained model for solutions of polymers in supercritical fluids is introduced and applied to the system of hexadecane and carbon dioxide as a representative example. Fitting parameters of the model to the gas-liquid critical point…

Understanding the wetting properties of premelting films requires knowledge of the film's equation of state, which is not usually available. Here we calculate the disjoining pressure curve of premelting films, and perform a detailed…

Dewetting of ultra-thin polymer films near the glass transition exhibits unexpected front morphologies [G. Reiter, Phys. Rev. Lett., 87, 186101 (2001)]. We present here the first theoretical attempt to understand these features, focusing on…

In Part II of this study we consider two cases of three-phase coexistence. First, the capped capillary may allow for vapour, drop-like, and slab-like phases to coexist at the same values of temperature and chemical potential. Second, the…

We examine the discontinuous first-order superfluid $^3$He A to B transition in the vicinity of the polycritical point (2.232 mK and 21.22 bar). We find path-dependent transitions: cooling at fixed pressure yields a well defined transition…

Thin liquid films on surfaces are part of our everyday life, they serve e.g. as coatings or lubricants. The stability of a thin layer is governed by interfacial forces, described by the effective interface potential, and has been subject of…

We define a lattice model for the interaction of a polymer with water. We solve the model in a suitable approximation. In the case of a non-polar homopolymer, for reasonable values of the parameters, the polymer is found in a non-compact…