相关论文: Optimizing the Optical Properties of Tin Oxide Aer…
Titanium-based oxides are abundant, chemically stable, non-toxic, and highly versatile materials, with applications ranging from photovoltaics to catalysis. For rutile and anatase phases of Titanium dioxide (TiO2), the bandgap ranges from…
We report very large bandgap enhancement in SrTiO3 (STO) films (fabricated by pulsed laser deposition below 800 {\deg}C), which can be up to 20% greater than the bulk value, depending on the deposition temperature. The origin is…
The study uses AACVD technology with nitrogen carrier gas to make AZO thin films through which it determines structural, optical, and morphological changes from 0 to 20 percent aluminum doping. The depositions took place at 400 degrees…
We show that oxidation of phosphorene can lead to the formation of a new family of planar (2D) and tubular (1D) oxides and sub-oxides, most of them insulating. This confers to black phosphorus a native oxide that can be used as barrier…
The ability to control porosity in oxide thin films is one of the key factors that determine their properties. Despite the abundance of dry processes for the synthesis of oxide porous layers, the high porosity range is typically achieved by…
Titanium dioxide is one of the most widely used wide bandgap materials. However, the TiO2 deposited on a substrate is not always transparent leading to a loss in efficiency of the device, especially, the photo response. Herein, we show that…
Pulsed ArF laser annealing in air and in hydrogen atmosphere improves the optical properties of ZnO nanostructured films. Independently on the ambient atmosphere, laser annealing produces two major effects on the photoluminescence (PL)…
Thin films of magnesium doped zinc oxide (MZO) were synthesized using the sol gel method and annealed at different temperatures under ambient condition. The morphological properties of the post annealed MZO films were investigated using X…
A theoretical study of Al(1-x)Ga(x)N, based on full-potential linearized augmented plane wave method, is used to investigate the variations in the bandgap, optical properties and non-linear behavior of the compound with the variation of Ga…
This study reports on the optical, structural, and dielectric properties of aluminum tantalum oxide (Al$_x$Ta$_y$O$_z$) thin films deposited at low temperature on silicon and steel substrates by pulsed direct current reactive magnetron…
The complete subgap defect density of states (DoS) is measured using the ultrabroadband (0.15 to 3.5 eV) photoconduction response from p-type thin-film transistors (TFTs) of tin oxide, SnO, and copper oxide, Cu$_2$O. The TFT photoconduction…
We investigate the effect of controlled annealing on the structural and electronic phase evolution of Tin dioxide from Tin (II) oxyhydroxide prepared by simple precipitation method. Thermogravimetric analysis suggests a complex weight…
The prospects of scaling current photovoltaic technologies to terawatt levels remain uncertain. All-oxide photovoltaics could open rapidly scalable manufacturing routes, if only oxide materials with suitable electronic and optical…
Zinc nitride films were synthesized by reactive radio frequency (rf) magnetron sputtering of a zinc target using an Ar+N2 mixture. The as-deposited films were annealed in the air and O2 at 300 {\deg}C for 1 hr. The XRD measurements…
Bacterial infections are a common problem in daily life that can affect human health. Researchers are looking for valuable materials that can help prevent such infections and environmental pollutants. Thin films are a well-known application…
Gallium oxide is a wide-bandgap semiconductor which has been steadily growing in popularity due to its ultra-wide bandgap, suitability for harsh environments and distinctive opto-electrical properties. Notable applications include deep-UV…
Oxygen vacancies (VO), a common type of point defects in metal oxides materials, play important roles on the physical and chemical properties. To obtain stoichiometric oxide crystal, the pre-existing VO is always removed via careful…
Titanium dioxide is a photocatalytic substance of great practical importance. However, with its bandgap in the ultraviolet (UV) regime, native forms (undoped) of TiO2 generally exhibits poor photocatalytic activities under visible light.…
We present a study on the crystallization process of undoped and Ta doped TiO2 amorphous thin films. In particular, the effect of ultra-fast annealing treatments in environments characterized by different oxygen concentrations is…
Silica aerogels are nanoporous materials with exceptional optical and physical properties, making them promising candidates to enhance solar cell efficiency as antireflective coatings. This study synthesized hydrophobic silica aerogel thin…