相关论文: Sulfur and sulfur-oxide compounds as potential opt…
Doping of bulk semiconductors has revealed widespread success in optoelectronic applications. In the past few decades, substantial effort has been engaged for doping at the nanoscale. Recently, doped zero-dimensional quantum dots made of…
Blends of carbon nanotubes with conjugated polymer and fullerene derivatives are complex nanocomposite systems, which have recently attracted a great research interest for their photovoltaic ability. Therefore, gaining a better…
We investigate the time-dependent electronic transport in single-walled carbon nanotubes (SWCNTs) functionalized with Au clusters on CO gas exposure. Using a tight-binding Hamiltonian and the nonequilibrium Green's function (NEGF) formalism…
The work presents a comprehensive methodology to determine the Shielding Effectiveness (SE) of single-walled carbon nanotubes (SWCNTs)/polymer nanocomposites. Here, an algorithm based on Ant Colony Optimization (ACO) was employed to…
Density functional calculations were performed to systematically study a series of finite and infinite cluster-assembled silicon nanotubes (SiNTs). One-dimensional SiNTs can be prepared by proper assembly of hydrogenated cage-like silicon…
We have taken advantage of the native surface roughness and the iron content of AISI 316 stainless steel to direct grow multi-walled carbon nanotube (MWCNT) random networks by chemical vapor deposition (CVD) at low-temperature ($<…
Cu-Cr-O delafossite thin films were grown by metal-organic chemical vapor deposition with various extrinsic dopants (Al, Mg, Mn, Sc, Y, and Zn) targeted at 5 at % to investigate how such doping influences their structure and properties.…
Arc-discharge with carbon electrodes containing Ni and Y2O3 in the presence of Fe(CO)5 vapors have been investigated. It is found that unlike the cathode deposit, the web deposited in the chamber contains mainly metallic single-walled…
Two-dimensional materials have attracted tremendous attention for their fascinating electronic, optical, chemical and mechanical properties. However, the band gaps of most 2D materials reported are smaller than 2.0 eV, which greatly…
Polymeric membranes, including Polysulfone (PSf) membranes, are routinely used for water treatment. To enhance water permeation of above membranes, it is common to synthesize polymeric membranes with carbon nanotubes (CNTs) embedded in…
For terahertz (THz) wave applications, tunable and rapid modulation is highly required. When studied by means of optical pump-terahertz probe spectroscopy, single-walled carbon nanotubes (SWCNTs) thin films demonstrated ultrafast carrier…
We report electrical transport measurements through a semiconducting single-walled carbon nanotube (SWNT) with three additional top-gates. At low temperatures the system acts as a double quantum dot with large inter-dot tunnel coupling…
We experimentally demonstrate laser-driven deposition of single-walled carbon nanotubes (CNTs) in suspended core fibers (SCFs) for the first time. Two samples for each SCF type with three (SCF1) and four (SCF2) air holes are individually…
Using carbon nanotubes (CNTs) produced by chemical vapor deposition, we have explored different strategies for the preparation of carbon nanotube devices suited for electrical and mechanical measurements. Though the target device is a…
Two-dimensional transition metal dichalcogenides (TMDCs) have been extensively investigated due to their tunable properties. In this work, density functional theory (DFT) is employed to investigate the adsorption behavior and sensing…
Transition-metal nanoclusters exhibit structural and electronic properties that depend on their size, often making them superior to bulk materials for heterogeneous catalysis. However, their performance can be limited by sulfur poisoning.…
Recent experiments about the low temperature behaviour of a Single Wall Carbon Nanotube (SWCNT) showed typical Coulomb Blockade (CB) peaks in the zero bias conductance and allowed us to investigate the energy levels of interacting…
Structural defects are widely regarded as detrimental to the optoelectronic properties of monolayer transition metal dichalcogenides, leading to concerted efforts to eliminate defects via improved materials growth or post-growth…
Current methods for producing single-walled carbon nanotubes (SWNTs) lead to heterogeneous samples containing mixtures of metallic and semiconducting species with a variety of lengths and defects. Optical detection at the single nanotube…
Two dimensional materials such as graphene and transition metal dichalcogenides (TMDs) are promising for optical modulation, detection, and light emission since their material properties can be tuned on-demand via electrostatic doping. The…