相关论文: Pressure-Induced Separation of a Laminar Boundary …
The characteristics of three-dimensional laminar separation bubbles (LSBs), compared with their quasi-two-dimensional counterparts, are studied using direct numerical simulation. A three-dimensional suction-blowing distribution is applied…
A quantitative analysis illustrating salient features of a Laminar Separation Bubble (LSB), its transition forming coherent structures, and associated heat transfer has been performed on a flat plate for varying free stream turbulence (fst)…
We develop a model for steady, laminar boundary layers over small-scale textured surfaces. Although the texture is small relative to the boundary-layer thickness, it modifies the flow via a slip length. We use matched asymptotic expansions…
This study investigates laminar boundary layer separation over a fully porous Gaussian bump using pore-resolved direct numerical simulations. The bump is formed by randomly packed spheres. Compared to a solid bump, the porous surface…
Surface roughness becomes relevant if typical length scales of the system are comparable to the scale of the variations as it is the case in microfluidic setups. Here, an apparent boundary slip is often detected which can have its origin in…
The spatio-temporal dynamics of separation bubbles induced to form in a fully-developed turbulent boundary layer (with Reynolds number based on momentum thickness of the boundary layer of 490) over a flat plate are studied via direct…
The dynamic behavior of the slip length in a fluid flow confined between atomically smooth surfaces is investigated using molecular dynamics simulations. At weak wall-fluid interactions, the slip length increases nonlinearly with the shear…
Wall modelling in large-eddy simulation (LES) is necessary to overcome the prohibitive near-wall resolution requirements in high-Reynolds-number turbulent flows. Most existing wall models rely on assumptions about the state of the boundary…
Molecular dynamic (MD) simulation is used to study slip at the fluid-solid boundary in an unsteady flow based on the Stokes second problem. An increase in slip is observed in comparison to the steady flow for shear rates below the critical…
The air entrainment due to the turbulence in a free surface boundary layer shear flow created by a horizontally moving vertical surface-piercing wall is studied through experiments and direct numerical simulations. In the experiments, a…
This paper studies the nature of the effective velocity boundary conditions for liquid flow over a plane boundary on which small free-slip islands are randomly distributed. It is found that, to lowest order in the area fraction $\beta$…
The flow of viscous incompressible fluid over a periodically corrugated surface is investigated numerically by solving the Navier-Stokes equation with the local slip and no-slip boundary conditions. We consider the effective slip length…
Linear global instability of the three-dimensional (3-D), spanwise-homogeneous laminar separation bubble (LSB) induced by shock-wave/boundary-layer interaction (SBLI) in a Mach 7 flow of nitrogen over a $30^{\circ}-55^{\circ}$ double wedge…
Direct numerical simulations of spanwise-rotating turbulent channel flow with a parabolic bump on the bottom wall are employed to investigate the effects of rotation on flow separation. Four rotation rates of $Ro_b := 2\Omega H/U_b = \pm…
Motivated by experimental evidence of violations of the no-slip boundary condition for liquid flow in micron-scale geometries, we propose a simple, complementary experimental technique that has certain advantages over previous studies.…
Hydrophobic textured surfaces are studied for their low wettability and their capacity to create a 'slippery' fluid on the surface during lubrication. To this end, the flow between two parallel surfaces is numerically addressed by computing…
On the micro- and nanoscale, classical hydrodynamic boundary conditions such as the no-slip condition no longer apply. Instead, the flow profiles exhibit ``slip`` at the surface, which is characterized by a finite slip length (partial…
We perform direct numerical simulations of shock-wave/boundary-layer interactions (SBLI) at Mach number M = 1.7 to investigate the influence of the state of the incoming boundary layer on the interaction properties. We reproduce and extend…
The transitional boundary layer flow over a flat plate is investigated. The boundary layer flow is known to develop unstable Tollmien-Schlichting waves above a critical value of the Reynolds number. However, it is also known that this…
We model a slip boundary condition at fluid-solid interface of an arbitrary geometry in smoothed particle hydrodynamics and smoothed dissipative particle dynamics simulations. Under an assumption of linear profile of the tangential velocity…