相关论文: Novel rotor fault diagnostic method based on rlmd …
This paper presents a study on the reduction of the sampling frequency of the current signals of an induction motor, the reductions are performed by means time-decimation technique for digital signal processing. We have used the Fast…
The intelligent fault diagnosis of rotating mechanical equipment usually requires a large amount of labeled sample data. However, in practical industrial applications, acquiring enough data is both challenging and expensive in terms of time…
The scope of data-driven fault diagnosis models is greatly extended through deep learning (DL). However, the classical convolution and recurrent structure have their defects in computational efficiency and feature representation, while the…
A hybrid approach based on multirate signal processing and sensory data fusion is proposed for the condition monitoring and identification of fault signal signatures used in the Flight ECS (Engine Control System) unit. Though motor current…
The standing waves existed in radio telescope data are primarily due to reflections among the instruments, which significantly impact the spectrum quality of the Five-hundred-meter Aperture Spherical radio Telescope (FAST). Eliminating…
The state-of-the-art automotive radars employ multidimensional discrete Fourier transforms (DFT) in order to estimate various target parameters. The DFT is implemented using the fast Fourier transform (FFT), at sample and computational…
This paper addresses the problem of extracting periodic oscillatory features in vibration sig- nals for detecting faults in rotating machinery. To extract the feature, we propose an approach in the short-time Fourier transform (STFT) domain…
The proposed method introduces a parameter determination approach based on the minimum Fractal box dimension (FBD) of Variational Mode Decomposition (VMD) components, aiming to address the issue of manual determination of VMD decomposition…
Most wind turbines are remotely monitored 24/7 to allow for an early detection of operation problems and developing damage. We present a new fault detection method for vibration-monitored drivetrains that does not require any feature…
This work presents a new frequency acquisition method using semi-rotational frequency detection (SRFD) algorithm for a reference-less clock and data recovery (CDR) in a serial-link receiver. The proposed SRFD algorithm classifies the…
Ultra-high-speed spindle bearings challenge traditional vibration monitoring due to broadband noise, non-stationarity, and limited time-frequency resolution. We present a fast Short-Time Root-MUSIC (fSTrM) algorithm that exploits…
The synchrosqueezing transform, a kind of reassignment method, aims to sharpen the time-frequency representation and to separate the components of a multicomponent non-stationary signal. In this paper, we consider the short-time Fourier…
To push gate performance to levels beyond the thresholds for quantum error correction, it is important to characterize the error sources occurring on quantum gates. However, the characterization of non-Markovian error poses a challenge to…
This paper proposes a new approach to diagnose broken rotor bar failure in a line start-permanent magnet synchronous motor (LS-PMSM) using random forests. The transient current signal during the motor startup was acquired from a healthy…
Early and accurately detecting faults in rotating machinery is crucial for operation safety of the modern manufacturing system. In this paper, we proposed a novel Deep fault diagnosis (DFD) method for rotating machinery with scarce labeled…
Radio Frequency Interference (RFI) increasingly contaminates the radio astronomy spectrum, often exceeding astronomical signal amplitudes by 50-70 dB. Reliable detection and mitigation are therefore essential for studies of faint transient…
This article proposes a source-independent method for detecting faults along Transmission Lines (TL) to reduce the protection issues arising from Inverter-Based Resources (IBRs). In the proposed method, high-frequency waves are sent from…
The paper presents algorithms to realize effectively and accurately the stepped-frequency waveform reflectometry (SFWR), i.e. the reflectometric technique based on the use of sinusoidal bursts. This technique is useful for monitoring the…
The time-frequency map (TFM) is frequently used in condition monitoring, necessitating further processing to select an informative frequency band (IFB) or directly detect damage. However, selecting an IFB is challenging due to the…
We present a simple and fast method for incoherent dedispersion and fast radio burst (FRB) detection based on the Hough transform, which is widely used for feature extraction in image analysis. The Hough transform maps a point in the…