相关论文: A Second-Order Audio VCO-ADC with 103-dB-A Dynamic…

In this work, a 3.5 GS/s voltage-controlled oscillator (VCO) analog-to-digital converter (ADC) using multi-stage noise shaping (MASH) is presented. This 28nm CMOS ADC achieves second-order noise shaping in an easily-scalable, open-loop…

This paper presents a non-Hermitian physics-inspired voltage-controlled oscillator (VCO) topology, which is termed parity-time-symmetric topology. The VCO consists of two coupled inductor-capacitor (LC) cores with a balanced gain and loss…

This paper presents an analytical model on quadrature VCO (QVCO) phase noise performance as well as a wide-tuning triple band QVCO RFIC design. The phase noise model demonstrates the advantages of applying phase shift to quadrature coupling…

This paper presents the analytical design of a new wide tuning range and low-noise millimeter-wave voltage control oscillators (VCO) for 5G technology. The small signal model analysis and phase noise of the VCOs will be presented to…

This work presents the design and analysis of a sixth-order triple-coupled transformer-based tank, enabling third-harmonic expansion for mmWave VCOs. Unlike conventional fourth-order tanks, the proposed tank inherently supports three…

Traditionally, the output noise and power supply rejection of low-dropout regulators (LDOs) are optimized to minimize power supply fluctuations, reducing their impact on the low-frequency noise of target voltage-controlled oscillators…

The performance of active disturbance rejection control (ADRC) algorithms can be limited in practice by high-frequency measurement noise. In this work, this problem is addressed by transforming the high-gain extended state observer (ESO),…

We propose a new method to measure the system noise temperature, $T_{\rm sys}$, using a 2-bit analog-to-digital converter (ADC). The statistics of the digitized signal in a four-level quantization brings us information about the bias…

This paper presents a 17 bit analogue-to-digital converter that incorporates mismatch and quantisation noise-shaping techniques into an energy-saving 10 bit successive approximation quantiser to increase the dynamic range by another 42 dB.…

Neural audio codecs have been widely studied for mono and stereo signals, but spatial audio remains largely unexplored. We present the first discrete neural spatial audio codec for first-order ambisonics (FOA). Building on the WavTokenizer…

This paper presents an active disturbance rejection control (ADRC) scheme with an improved fractional-order extended state observer (IFO-ESO).Based on the new ADRC scheme, the open-loop transfer function of a high-order system can be…

This paper presents a low-area and low-power consumption CMOS differential current controlled oscillator (CCO) for neuromorphic applications. The oscillation frequency is improved over the conventional one by reducing the number of MOS…

Low-power quadrature voltage-controlled oscillator (QVCO) design utilizing transformer-feedback and current-reuse techniques with increased frequency range is proposed in this paper. With increasing demand for QVCOs in on-chip applications,…

Due to the power consumption and high circuit cost in antenna arrays, the practical application of massive multiple-input multiple-output (MIMO) in the sixth generation (6G) and future wireless networks is still challenging. Employing…

Nanopositioning systems frequently encounter limitations in control bandwidth due to their lightly damped resonance behavior. This paper presents a novel Non-Minimum-Phase Resonant Controller (NRC) aimed at active damping control within…

Low-resolution analog-to-digital converters (ADCs) have emerged as an efficient solution for massive multiple-input multiple-output (MIMO) systems to reap high data rates with reasonable power consumption and hardware complexity. In this…

We analyze the continuous variable (CV) dense coding protocol between a single sender and a single receiver when affected by noise in the shared and encoded states as well as when the decoding is imperfect. We derive a general formalism for…

Active noise control (ANC) has been widely utilized to reduce unwanted environmental noise. The primary objective of ANC is to generate an anti-noise with the same amplitude but the opposite phase of the primary noise using the secondary…

To enable low-power and low-complexity wireless monitoring, an improved circuit design of Analog Joint Source Channel Coding (AJSCC) is proposed for wireless sensor nodes. This innovative design is based on Analog Divider Blocks (ADB) with…

A prototype of a very high dynamic range 32-bits Digital to Analog Converter (DAC) was designed and built for the purpose of direct auditory stimulus generation. It provides signals from less than 100 nV up to 50 Watts peak power output,…