相关论文: Achieving Single-Electron Sensitivity at Enhanced …

MiniCACTUS is a monolithic sensor prototype optimised for timing measurement of charged particles. It has been designed in a standard 150 nm CMOS process without dedicated amplification layer. It is intended as a demonstrator chip for…

Scalable, high speed data transfer between cryogenic (0.1-4 K) and room temperature environments is instrumental in a broad range of fields including quantum computing, superconducting electronics, single photon imaging and space-based…

The radio frequency single electron transistor (rf-SET) possesses key requirements necessary for reading out a solid state quantum computer. This work explores the use of the rf-SET as a single-shot readout device in the presence of 1/f and…

We present a versatile analytic model describing Photon Detection Efficiency (PDE) for P-on-N silicon photomultipliers, with possible applications for device characterization, PDE extrapolation from limited data, simulation and design…

Future high-resolution imaging X-ray observatories may require detectors with both fine spatial resolution and high quantum efficiency at relatively high X-ray energies (>5keV). A silicon imaging detector meeting these requirements will…

This study investigates the charging-up effect on the Topmetal-II- chip in Gas Micro-Pixel Detectors(GMPD). It is found that this effect differs from the charging-up typically observed in gas detector multiplier devices and increases the…

Multichip modules (MCM) with 4 single photon counting MPEC 2.3 chips bump bonded to 1.3 cm x 1.3 cm large CdTe and Si semiconductor sensors as well as to single chip pixel detectors have been successfully built and operated. The MPEC 2.3…

An amplifier has been designed for optimal use of position sensitive thermal neutron detectors using the principle of resistive charge division. The important points in this optimization are: high counting rates and good spatial resolution.…

Single-photon detection via absorption in current-biased nanoscale superconducting structures has become a preferred technology in quantum optics and related fields. Single-mode fiber packaged devices have seen new records set in detection…

Advanced electronic device technologies require a faster operation and smaller average power consumption, which are the most important parameters in very large scale integrated circuit design. The conventional Complementary Metal-Oxide…

Efficiency and multisimultaneous-frequency (MSF) output capability are two major criteria characterizing the performance of a power amplifier in the application of multifrequency eddy current testing (MECT). Switch-mode power amplifiers are…

We present the first limits on inelastic electron-scattering dark matter and dark photon absorption using a prototype SuperCDMS detector having a charge resolution of 0.1 electron-hole pairs (CDMS HVeV, a 0.93 gram CDMS HV device). These…

In this work, we present a novel device that is a combination of a superconducting nanowire single-photon detector and a superconducting multi-level memory. We show that these devices can be used to count the number of detections through…

We demonstrate so-called repetitive non-destructive readout (RNDR) for the first time on a Single electron Sensitive Readout (SiSeRO) device. SiSeRO is a novel on-chip charge detector output stage for charge-coupled device (CCD) image…

A novel topology for a high gain two-stage amplifier is proposed. The proposed circuit is designed in a way that the non-dominant pole is at output of the first stage. A positive capacitive feedback (PCF) around the second stage introduces…

The Kitt Peak Electron Multiplying CCD (EMCCD) demonstrator is a new instrument that has been developed for use at the Kitt Peak National Observatory's 84-inch telescope. The EMCCD enables single-band optical imaging in the Sloan \textit{g}…

Efficiency droop, i.e., a decline in brightness of LEDs at high electrical currents, has limited the performance of all commercially available LEDs. Until now, it has limited the output power of sub-micron LEDs and lasers to nanowatt range.…

We report on an apparatus able to measure the absolute detection efficiency of a detector for electrons in the 30 - 900 eV range. In particular, we discuss the characterisation of a two-stage chevron microchannel plate (MCP). The…

Ultrafast, high quantum efficiency single photon detectors are among the most sought-after elements in modern quantum optics and quantum communication. High photon detection efficiency is essential for scalable measurement-based quantum…

We demonstrate the effectiveness of two techniques for using x-rays to evaluate the amount of charge diffusion in charge coupled devices (CCDs). We quantify the degree of charge diffusion with two parameters: sigma_d, the standard deviation…